Question is ⇒ Karnaugh map can not be drawn when the number of variables is more than 4, Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Karnaugh map can not be drawn when the number of variables is more than 4, Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Karnaugh map can not be drawn when the number of variables is more than 4
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ Decimal number 10 is equal to binary number
1110
1010
1001
1000

⇒ The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is
[0, - 2 + 2j, 2, - 2 - 2j]
[2, 2 + 2j, 6, 2 - 2j]
[6, 1 - 3j, 2, 1 + 3]
[6, - 1 + 3j, 0, - 1 - 3j]

⇒ Is Schottky TTL, Schottky diode is used primary to
prevent saturation of the transistor
saturate the transistor
act as a switch
act as a controlling switch

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be
448 kHz
555 kHz
625 kHz
712 kHz

⇒ In a series RLC circuit, the current at resonance is I₀ the total energy stored in the circuit at resonance is
LI₀²
2 LI₀²
2 LI₀²
0.5 LI²

⇒ A series LCR circuit consisting of R = 20 Ω, | X_L | = 20 Ω and | X_C | = 20 Ω, connected across an A.C. supply of 200 V rms. The rms voltage across the capacitor is
100 ∠ 45
400 ∠ -90°
400 ∠ +90°
100 ∠ -45

⇒ Resonant circuits are used in
audio amplifiers
RF amplifiers
both audio and RF amplifiers
none of the above

⇒ Mobility is directly proportional to Hall coefficient.
TRUE
FALSE

⇒ Resistivity is a property of a semiconductor that depends on
the atomic weight of the semiconductor
the atomic number of the semiconductor
the atomic nature of the semiconductor
the shape of the semiconductor

⇒ Which of the following form of angle modulation in this? If e = 10 sin(10⁸ t + 3 sin 10⁴ t)
AM
FM
AM or FM
AM or PCM

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ Which of the following laws of electromagnetic theory is associated with the force experienced by two loops of a wire carrying currents?
Maxwell's law
Coulomb's law
Ampere's law
Laplace's law

⇒ The ripple factor for a bridge rectifier is
0.406
1.21
1.11
2.22

⇒ For the wave shown in figure, the average valu
7.07 A
0.208333333333333
2.5 A
0.5 A

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ The rate of change of digital signals between High and Low level is
very fast
fast
slow
very slow

⇒ A moving iron instrument has
two iron vanes, one fixed and one movable
two movable iron vanes
two aluminium vanes, one fixed and one movable
two vanes, one fixed made of Aluminium and the other movable made of iron

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25

⇒ A cut set schedule shows
incidence of branches to loops
incidence of branches to nodes
incidence of nodes to loops
none of the above

⇒ While AM has __________ frequencies, FM has __________ number of sidebands.
2, 3
3, 3
3, 5
3, infinite

⇒ The Darlington pair consists of the following two stages
CE and CC
both CE
both CC
CE and CB

⇒ A feedback amplifier has forward gains A₁, A₂ and feedback factor β as shown in signal flow graph of the given figure. Because of feedback as shown in signal noise ratio at output
increase
decrease
be unaffected
depend on value of β

⇒ A pulse train can be delayed by a finite number of clock periods by using
serial in-serial out shift register
parallel in serial out shift register
serial in-parallel out shift register
parallel in parallel out shift register

⇒ Figure shows a portion of linear v - i characteristics of diode. If applied voltage is + 6 V, the current wil
42 mA
48 mA
51 mA
54 mA

⇒ The minterm designation for ABCD is
m₁₁
m₁₃
m₁₅
m₁₆

⇒ For a = - 1, find the value of V_{2∞
0
V₁
none of the above}

⇒ Generally the wall thickness of rectangular waveguide is
about 1-5 mils
about 40-100 mils
about 0.1 to 0.5 mils
about 500 mils

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2