Question is ⇒ Junction temperature is always the same as room temperature., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Junction temperature is always the same as room temperature., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Junction temperature is always the same as room temperature.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The applications of shift registers are

Time delay
Ring counter
Serial to parallel data conversion
Serial to serial data conversion

Which of the above are correct?
1, 2, 3
2, 3, 4
1, 2, 3, 4
1, 2, 4

⇒ An ac network has two sources of the same frequency. The currents in one branch when the sources act independently are 10 ∠30° A and 10 ∠60° A. When both sources act, the current in the branch should be
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ The function (s + 2) (s + 4)/[(s + 1)(s + 3)]
is a reactance function
is an RC function
may be a reactance function or an RC function
may be RC function or an RL function

⇒ Consider the following features of 'structures' in C?

The values of a structure variable can be assigned to another structure variable of the same type using the assignment operator.
One structure can be nested within another structure.
A variable structure can also be passed to a function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about
50 or more
10 or more
25 or more
200 or more

⇒ If the AF voltage is raised to 10 V, while the AM is dropped to 200 Hz, what is the deviation?
10 kHz
15 kHz
20 kHz
40 kHz

⇒ In case of low level amplitude modulation system, the amplifiers following the modulated stage must be
class C amplifiers
linear devices
non-linear devices
harmonic devices

⇒ In telephone, the dial tone has a frequency of
5 Hz
15 Hz
33 Hz
233 Hz

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get
zero power
∞ power
depend upon input signal strength
depend on frequency

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒ For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be
50 Hz
100 Hz
200 Hz
400 Hz

⇒ Which of the following antenna is best guided by a waveguide?
Biconical
Horn
Helical
Dish

⇒ The primary function of lag compensator is to provide sufficient
gain margin
phase margin
both gain margin and phase margin
either (a) or (b)

⇒ A 3-digit voltmeter having a resolution of 100 mV can be used to measure a maximum of
100 V
200 V
1000 V
5000 V

⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒

Assertion (A): L[af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)

Reason (R): Initial value theroem enables us to find the value of f(t) at t = 0 directly from F(s)

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following statements:

In the 2's complement representation, negative numbers are stored in sign magnitude form.
Taking 2's complement is equivalent to sign change.
In a 4 bit complement representation of a binary number A.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.

Of these, the only true statements are
(I) and (III)
(I) and (IV)
(II) and (III)
(II) and (IV)

⇒ In the above case if another sine wave corresponding to 40% modulation is transmitted simultaneously, the total radiated power will be
9.9 kW
10.15 kW
10.84 kW
18.4 kW

⇒ The addition of a zero to the open loop transfer function
pulls the root locus to the left and makes the system more stable
pulls the root locus to the right and makes the system less stable
either (a) or (b)
neither (a) nor (b)

⇒ Full adder circuit can be implemented by
Multiplexers
Half adders
AND or OR gates
Decoders

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be
24.09 MHz
24.54 MHz
25.45 MHz
25.91 MHz

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
electrostriction
acousto-optic interaction
acousto-electric interaction
stimulated Brillouin scattering

⇒ For the given truth table, the correct Boolean expressio
XYZ + X YZ + X Y Z
X Y Z + XYZ + X YZ
X Y Z + XYZ + XY Z
XYZ + XYZ + XY Z

⇒ The input resistance R, of an ideal voltage amplifier is __________ and that of a current amplifier is __________ .
zero, zero
infinite, infinite
zero, infinite
infinite, zero