Question is ⇒ It is required that a strain gauge has gauge factor of 100. The proper strain gauge is, Options are ⇒ (A) constantan strain gauge, (B) nichrome strain gauge, (C) semiconductor strain gauge, (D) alloy strain gauge, (E) , Leave your comments or Download question paper.

Question is ⇒ It is required that a strain gauge has gauge factor of 100. The proper strain gauge is, Options are ⇒ (A) constantan strain gauge, (B) nichrome strain gauge, (C) semiconductor strain gauge, (D) alloy strain gauge, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	It is required that a strain gauge has gauge factor of 100. The proper strain gauge is
A.	constantan strain gauge [Wrong Answer]
B.	nichrome strain gauge [Wrong Answer]
C.	semiconductor strain gauge [Correct Answer]
D.	alloy strain gauge [Wrong Answer]
View Answer 4 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements as regards DPSK and DEPSK

DPSK demodulator requires a device which operates at carrier frequency and provides a delay of bit time T_b
In DPSK, synchronous demodulation recovers the signal b(t) and the decoding of b(t) to generate d(t) is done at base band
In both DPSK and DEPSK errors always occur in pairs

Which of the above statements are correct?
1 and 3
1 and 2
2 and 3
1, 2 and 3

⇒ In response to a unit step input the controller output in given figure is
proportional controller
proportional plus integral controller
integral controller
none of the above

⇒ The reactance of coupling capacitor for AC signals in an amplifier, should be
as low as possible
as high as possible
neither low nor high
either low or high

⇒ In the saturation region of CE output characteristics of n-p-n transistor, V_CE is about
0.5 V
15 V
- 0.5 V
- 15 V

⇒ In disc mounting of SCR
SCR is clamped on one side of disc shaped heat sink
SCR is clamped between two disc shaped heat sinks
The SCR has low current rating
None of the above

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ Which of the following is a valid FORTRAN assignment statement?
10 = N
X + 2.1 = 5.6
A = B
A = B = 1

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ Which of the following characteristic are necessary for a sequential circuit?

It must have 6 gates
It must have feedback
Its output should depend on past value

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3

⇒ In Pascal the repeat and while loops will terminate
only when the logical expression controlling the loop becomes true for both repeat and while loops
only when the logical expression controlling the loop becomes false for both repeat and while loops
only when the logical expression controlling the loop becomes true for repeat loop and false for while loop
only when the logical expression controlling the loop becomes false for repeat loop and true for while loop

⇒ An R-L series circuit is excited by a voltage v(t). The circuit was initially relaxed. Which of the following sources of v(t) would cause maximum current at t = 0⁺?
unit step
unit impulse
unit ramp
unit step plus unit ramp

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is
0 ≤ a ≤ p
θ ≤ a ≤ p
0 ≤ a ≤ (p - θ)
θ ≤ a ≤ (p + θ)

⇒ In a current transformers
the number of turns in primary and secondary windings are nearly equal
the number of primary turns is very small as compared to number of secondary turns.
the number of secondary turns is very small as compared to the number of primary turns
either (a) or (c).

⇒ Which one of the following can be used as parallel to series converter?
Decoder
Digital counter
Multiplexer
Demultiplexer

⇒ In a transistor leakage current mainly depends on
doping of base
size of emitter
rating of transistor
temperature

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ A voltage V(t) is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt². If it is measured by a dc meter. The reading will be
0
4
2
2

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ An insulator will conduct when the
voltage applied is more than the breakdown voltage
temperature is raised to very high level
either (a) or (b) above
none of the above

⇒ A rare gas having N atoms/m³ is subjected to an electric field E. The electric dipole moment per unit volume is proportional to N and E.
TRUE
FALSE

⇒ In the spectrum of a FM wave
the carrier frequency cannot disappear
the carrier frequency disappears when the modulation index is large
the amplitude of any sideband depends on the modulation index
the total number of sidebands depends on the modulation index

⇒ Which one of the following is not a characteristic of a ferroelectric material?
High dielectric constant
No hysteresis
Ferroelectric characteristic only above the curie point
Electric dipole moment

⇒ The factor η for a UJT is about
0.1
0.2
0.6
0.9

⇒ In the expression a = 5 * 2 / 3.2 + 4 / 8 - 2 + 5 / 9 which operation will have the first priority in C?
5*2
2 / 3.2
5 * 2 / 3.2
42833

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒ The number of programmable 16 bit registers of 6800 are
2
3
4
5

⇒ As per time displacement theorem in Laplace transformation, displacement in the time domain by T becomes
division by s in the s domain
division by e^-sT in the s domain
multiplication by s in the s domain
multiplication by e^-sT in the s domain

⇒ Two 2 port circuits are connected cascaded. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters