Question is ⇒ It is desired to route data from many registers to one register. The device needed is, Options are ⇒ (A) decoder, (B) multiplexer, (C) demultiplexer, (D) counter, (E) , Leave your comments or Download question paper.

Question is ⇒ It is desired to route data from many registers to one register. The device needed is, Options are ⇒ (A) decoder, (B) multiplexer, (C) demultiplexer, (D) counter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	It is desired to route data from many registers to one register. The device needed is
A.	decoder [Wrong Answer]
B.	multiplexer [Correct Answer]
C.	demultiplexer [Wrong Answer]
D.	counter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A decade counter skips
binary states 1000 to 1111
binary states 0000 to 0011
binary states 1010 to 1111
binary states 1111 to higher

⇒ A dc chopper V = 500 V feeds an electric fraction dc series motor. The chopping frequency is 400 Hz. The series inductance required to limit the maximum current swing to 10 A is
20 mH
about 31 mH
about 51 mH
about 92 mH

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ If Y(s) = 1 + s, the network has
1 Ω resistor and 1 F capacitor in series
1 Ω resistor and 1 F capacitor in parallel
1 Ω resistor and 1 H inductor in series
1 Ω resistor and 1 H inductor in parallel

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ For a type 1 system and unit parabolic input, the steady state error is
0
∞
1
1/K_v

⇒ The current gain of a BJT is
g_m r₀
g_m/r₀
g_m r_p
g_m/r_p

⇒ x = AX + Bu is a state equation.
TRUE
FALSE

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with e_r = 15. The reflection coefficient for normal incidence is
0.6 ∠0°
1 ∠0°
0.6 ∠180°
1.2 ∠180°

⇒ The following switching functions are to be implemented using a decoder

f₁ = ∑m (1, 2, 4, 8, 10, 14)
f₂ = ∑m (2, 5, 9, 15)
f₃ = ∑m (2, 4, 5, 6, 7)

The minimum configuration of decoder is
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line

⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is
zero
24.14A
10A
14.14A

⇒ The concentration of minority carriers in an extrinsic semiconductor under equilibrium is
directly proportional to the doping concentration
inversely proportional to doping concentration
directly proportional to intrinsic concentration
inversely proportional to the intrinsic concentration

⇒ In the given figure the reflected current wave after first reflectio
0.18 A
-0.18 A
0.3 A
-0.3 A

⇒ Choose correct option for a stable system :

Roots of the characteristic equation of the system are real and negative
Area within the impulse response is finite

I is true, II is true
I is true, II is false
I is false, II is true
I is false, II is false

⇒ The maximum effective aperture of λ/2 (half-wave) antenna is
0.013 λ²
0.13 λ²
1.3 λ²
13 λ²

⇒ If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the
forward active mode
reverse saturation mode
reverse active mode
forward saturation mode

⇒ In a varactor diode the increase in width of depletion layer results in
decrease in capacitance
increase in capacitance
no change in capacitance
either (a) or (b)

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ When all the seven segments of a display are energized, the number shown is
0
1
7
8

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ Which of these has degenerate p and n materials?
Zener diode
PIN diode
Tunnel diode
Photo diode

⇒ The term 'energy spectral density' is associated with
periodic waveform
non-periodic waveform
both perodic and non -perodic waveform
none of the above

⇒ The number of LED display indicators in logic probe are
1
2
1 or 2
4

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ RF choke used for suppressing interference in TV is generally
honey comb wound coil
iron core coil
single layer coil
multilayer coil

⇒ A number given in binary as 0101.01 is to be scaled up 4 times. The scaled up binary is
10101
1.0101
404.04
10.101

⇒ Rise time in a transistor is change from
10% of its final value to 90% of its final value
0% of its final value to 90% of its final value
10% of its final value to 100% of its final value
10% to its final value to 50% of its final value

⇒

Match the following:

	List I (Transmission system)		List II (Mode)
A.	Rectangular waveguide	1.	TE/TM
B.	Circular waveguide	2.	TEM
C.	Coaxial line	3.	Quasi TEM
D.	Microstrip line

A-1, B-1, C-2, D-3
A-1, B-2, C-2, D-3
A-2, B-2, C-3, D-3
A-3, B-1, C-2, D-2

⇒ Which of the following statements is correct?
Convex lens has positive focal power and concave lens have negative focal power
Convex lens has negative focal power and concave lens have positive focal power
All lens have positive focal power
All lens have negative focal power