Question is ⇒ Intrinsic or characteristic impedance of free space has a value of, Options are ⇒ (A) 120 ohm, (B) 73 ohm, (C) 73 ε ohm, (D) 120 ε ohm, (E) , Leave your comments or Download question paper.

Question is ⇒ Intrinsic or characteristic impedance of free space has a value of, Options are ⇒ (A) 120 ohm, (B) 73 ohm, (C) 73 ε ohm, (D) 120 ε ohm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Intrinsic or characteristic impedance of free space has a value of
A.	120 ohm [Wrong Answer]
B.	73 ohm [Wrong Answer]
C.	73 ε ohm [Wrong Answer]
D.	120 ε ohm [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The most commonly used semiconductor material is
silicon
germanium
mixture of silicon and germanium
none of the above

⇒ Which of following digital modulation technique?
ASK
FSK
PSK
All

⇒ The circuit in figur
CE amplifier
CB amplifier
Constant voltage source
Constant current source

⇒ A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE₁₁ mode. The minimum operating frequency is
6.25 GHz
6.0 GHz
5.0 GHz
3.75 GHz

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ A TE₁₀ rectangular waveguide is to be designed for operation over 25-35 GHz and the band centre is 1.5 times the cutoff frequency. The dimension of broadside is
15 mm
10 mm
9 mm
7.5 mm

⇒ The radiation resistance of a circular loop of one turn is 0.01 ohm. For 5 turn loop the radiation resistance is
0.002 Ω
0.01 Ω
0.05 Ω
0.25 Ω

⇒ A voltage doubler circuit uses
two diodes
two capacitors
two diodes and two capacitors
none of the above

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒ The correct relation between energy and charge is
Energy = voltage/charge
Charge = Energy x voltage
Energy = voltage (charge)^0.5
Energy = voltage x charge

⇒ The coupling capacitor mainly affects
bandwidth
lower cut-off frequency
higher cut-off frequency
both lower as well as higher cut-off frequency

⇒ Two voltmeters are each 0-300 V range. Their internal resistances are 10 kΩ and 20 kΩ They are connected is series and a voltage of 400 V is applied. Their readings respectively will be
266.6 and 133.3 V
133.3 and 266.6 V
200 V each
100 and 300 V

⇒ The Gain margin for the system with open loop transfer functi
∞
0
1
-∞

⇒

Match the following:

	List I		List II
A.	AM-DSB FC	1.	2
B.	WBFM	2.	1
C.	PCM	3.	3m
D.	AM-DSB	4.	2^2N

A-1, B-2, C-3, D-4
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1

⇒ The given characteristic polynomial s⁴ + s³ + 2s² + 2s + 3 = 0 has
zero root in RHS of s-plane
one root in RHS of s-plane
two roots in RHS of s-plane
three roots in RHS of s-plane

⇒ In a bipolar transistor
recombination in base regions of both n-p-n and p-n-p transistor is low
recombination in base regions of both n-p-n and p-n-p transistors is high
recombination in base region of n-p-n transistor is low but that in p-n-p transistor is high
recombination in base region of p-n-p transistor is low but that in n-p-n transistor is high

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ A dc chopper is feeding an RLE load. The condition for maximum ripple is
a = 1
a = 0.8
a = 0.5
a < 0.5

⇒ Energy content of atmospheric noise
does not depend on frequency
decreases as frequency is increased
increases as frequency is increased
either (a) or (c) depending on the temperature

⇒ One limitation of constant k filters is that Z₀ is not constant in the pass band.
TRUE
FALSE

⇒ Which of the following are universal gates?

NAND
NOR
XOR

Select the correct answer from the codes given below:
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ The output V_R of the ratio detector is related with the output V_F of similar Foster-Seeley discriminator as follows.
V_R = V_F
V_R < V_F
V_R = 2V_F
V_F = 2V_R

⇒ The following table gives some Laplace transforms and the functions

	f(t)	F(s)
1.	δ(t)	s
2.	u(t)	1/s
3.	tu(t)	2/s²
4.	t²u(t)	2s³

le>Of these the correctly matched pairs are
2 and 4
1 and 4
2 and 4
1 and 2

⇒ Which of the following is not an application software?
MS Word
DBMS
Worksheet
Lisp

⇒ A 200 turn coil has a self inductance of 10 mH. If the number of turns is doubled, all other quantities remaining the same, the self inductance will be
2.5 mH
5 mH
20 mH
40 mH

⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7

⇒ A klystron amplifier generally uses Pierce gun
TRUE
FALSE

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point