Question is ⇒ In which of the following voltage regulators the effect of dead zero is found ?, Options are ⇒ (A) Electromagnetic type, (B) Magnetic amplifier, (C) Electronic type using integrated circuits, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In which of the following voltage regulators the effect of dead zero is found ?, Options are ⇒ (A) Electromagnetic type, (B) Magnetic amplifier, (C) Electronic type using integrated circuits, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which of the following voltage regulators the effect of dead zero is found ?
A.	Electromagnetic type [Correct Answer]
B.	Magnetic amplifier [Wrong Answer]
C.	Electronic type using integrated circuits [Wrong Answer]
D.	All of the above [Wrong Answer]
View Answer 26 -9 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The voltage drop, for constant voltage transmission is compensated by installing
inductors
capacitors
synchronous motors
all of above

⇒ The string efficiency of an insulator can be increased by
correct grading of insulators of various capacitances
reducing the number of strings
increasing the number of strings in the insulator
none of the above

⇒ When a conductor carries more current on the surface as compared to core, it is due to
permeability variation
corona
skin effect
unsymmetrical fault

⇒ Which of the following characteristics should the line supports for transmission lines possess ?
Low cost
High mechanical strength
Longer life
All of the above

⇒ The presence of ozone due to corona is harmful because it
reduces pawer factor
corrodes the material
gives odour
transfer energy to the ground

⇒ If the height of transmission tower is increased
the line capacitance will decrease but line inductance will remain unchanged
the line capacitance and inductance will not change
the line capacitance will increase but line inductance will decrease
the line capacitance will decrease and line inductance will increase

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ In aluminium conductors, steel core is provided to
compensate for skin effect
neutralise proximity effect
reduce line inductance
increase the tensile strength

⇒ Which of the following bar schemes is the most expensive ?
Double bus-bar double breaker
Ring bus-bar scheme
Single bus-bar scheme
Main and transfer scheme

⇒ Which of the following is the source of heat generation in the cables ?
Dielectric losses in cable insulation
IR losses in the conductor
Losses in the metallic sheathings and armourings
All of the above

⇒ For aluminium, as compared to copper, all the following factors have higher values except
specific volume
electrical conductivity
co-efficient of linear expansion
resistance per unit length for same cross-section

⇒ Ground wire is used to
avoid overloading
give the support to the tower
give good regulation
connect, a circuit conductor or other device to an earth-plate

⇒ High voltage is primarily used, for long distance power transmission, to
reduce the time of transmission
reduce the transmission losses
make the system reliable
none of the above

⇒ By using bundled conductors which of the following is reduced ?
Power loss due to corona
Capacitance of the circuit
Inductance of the circuit
None of the above

⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than
80 km
110 km
150 km
210 km

⇒ In a tap changing transformer, the tappings are provided on
primary winding
secondary winding
high voltage winding
any of the above

⇒ By using bundle conductors, the critical voltage for the formation of corona will
remain same
decrease
increase
not occur

⇒ Due to which of the following reasons the cables should not, be operated too hot ?
The oil may loose its viscosity and it may start drawing off from higher levels
Expansion of the oil may cause the sheath to burst
Unequal expansion may create voids in the insulation which will lead to ionization
The thermal instability may rise due to the rapid increase of dielectric losses with temperature

⇒ Pin type insulators are generally not used for voltages beyond
1 kV
11 kV
22 kV
33 kV

⇒ The square root of the ratio of line impedance and shunt admittance is called the
surge impedance of the line
conductance of the line
regulation of the line
none of the above

⇒ Aluminium has a specific gravity of
1.5
2.7
4.2
7.8

⇒ High voltage transmission lines use
suspension insulators
pin insulators
both (a) and (b)
none of the above

⇒ If the height of transmission tower is increased, which of the following; parameters is likely to change ?
Capacitance
Inductance
Resistance
All of the above

⇒ System grounding is done so that
inductive interference between power and communication circuits can be controlled
the floating potential on the lower voltage winding for a transformer is brought down to an insignificant value
the arcing faults to earth would not set up dangerously high voltage on healthy phases
for all above reasons

⇒ The ground ring transmission lines are used to
reduce the transmission losses
reduce the earth capacitance of the lowest unit
increase the earth capacitance of the lowest unit
none of the above

⇒ The spacing between phase conductors of a 220 kV line is approximately equal to
2 m
3.5 m
6 m
8.5 m

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ In a D.C. 3-wire distributor using balancers and having unequal loads on the two sides
both balancers run as generators
both balancers run as motors
balancer connected to lightly- loaded side runs as a motor
balancer connected to heavily- loaded side runs as a motor

⇒ With which of the following are step-up substations associated ?
Concentrated load
Consumer location
Distributors
Generating stations

⇒ The use of strain type insulators is made where the conductors are
dead ended
at intermediate anchor towers
any of the above
none of the above