Question is ⇒ In which of the following cases shunt capacitance is negligible ?, Options are ⇒ (A) Short transmission lines, (B) Medium transmission lines, (C) Long transmission lines, (D) All transmission lines, (E) , Leave your comments or Download question paper.

Question is ⇒ In which of the following cases shunt capacitance is negligible ?, Options are ⇒ (A) Short transmission lines, (B) Medium transmission lines, (C) Long transmission lines, (D) All transmission lines, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which of the following cases shunt capacitance is negligible ?
A.	Short transmission lines [Correct Answer]
B.	Medium transmission lines [Wrong Answer]
C.	Long transmission lines [Wrong Answer]
D.	All transmission lines [Wrong Answer]
View Answer 5 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A uniformly-loaded D.C. distributor is fed at both ends with equal voltages. As compared to a similar distributor fed at one end only, the drop at the middle point is
one-fourth
one-third
one-half
twice

⇒ If string efficiency is 100 percent it means that
potential across each disc is zero
potential across each disc is same
one of the insulator discs is shorted
none of the above

⇒ For an overhead line, the surge impedance is taken as
20-40 ohms
70-80 ohms
100-200 ohms
500-1000 ohms

⇒ The material generally used for armour of high voltage cables is
aluminium
steel
brass
copper

⇒ Due to which of the following reasons aluminium is being favoured as busbar material ?
Low density
Low cost
Ease of fabrication
None of the above

⇒ The conductors are bundled primarily to
increase reactance
reduce reactance
reduce radio interference
none of the above

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ The spacing between phase conductors of a 220 kV line is approximately equal to
2 m
3.5 m
6 m
8.5 m

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ For which of the following, the excitation control method is satisfactory ?
Low voltage lines
High voltage lines
Short lines
Long lines

⇒ The phenomenon of rise in voltage at the receiving end of the open-circuited or lightly loaded line is called the
Seeback effect
Ferranti effect
Raman effect
none of the above

⇒ The steel used in steel cored conductors is usually
alloy steel
stainless steel
mild steel
high speed steel

⇒ The loads on distributors systems are generally
balanced
unbalanced
either of the above
none of the above

⇒ ____ are the conductors, which connect the consumer's terminals to the distribution
Distributors
Service mains
Feeders
None of the above

⇒ A synchronous condenser is generally installed at the of the ____ transmission line
receiving end
sending end
middle
none of the above

⇒ Resistance grounding is used for voltage between
33 kV to 11 k V
11 kV to 33 kV
33 kV to 66 kV
none of the above

⇒ The limit of distance of transmission line may be increased by the use of
series resistances
shunt capacitors and series reactors
series capacitors and shunt reactors
synchronous condensers

⇒ The skin effect of a conductor will reduce as the
resistivity of conductor material increases
permeability of conductor material increases
diameter increases
frequency increases

⇒ The usual spans with R.C.C. poles are
40-50 metres
60-100 metres
80-100 metres
300-500 metres

⇒ For which of the following equipment current rating is not necessary ?
Circuit breakers
Isolators
Load break switch
Circuit breakers and load break switches

⇒ In a tap changing transformer, the tappings are provided on
primary winding
secondary winding
high voltage winding
any of the above

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ The string efficiency of an insulator can be increased by
correct grading of insulators of various capacitances
reducing the number of strings
increasing the number of strings in the insulator
none of the above

⇒ Constant voltage transmission entails the following disadvantage
large conductor area is required for same power transmission
short-circuit current of the system is increased
either of the above
none of the above

⇒ The square root of the ratio of line impedance and shunt admittance is called the
surge impedance of the line
conductance of the line
regulation of the line
none of the above

⇒ A booser is connected in
parallel with earth connection
parallel with the feeder
series with the feeder
series with earth connection

⇒ 310 km line is considered as
a long line
a medium line
a short line
any of the above

⇒ The material commonly used for sheaths of underground cables is
lead
rubber
copper
iron

⇒ In which of the following cases shunt capacitance is negligible ?
Short transmission lines
Medium transmission lines
Long transmission lines
All transmission lines

⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than
80 km
110 km
150 km
210 km