Question is ⇒ In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?, Options are ⇒ (A) TE01, (B) TE11, (C) TE05, (D) TE21, (E) , Leave your comments or Download question paper.

Question is ⇒ In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?, Options are ⇒ (A) TE01, (B) TE11, (C) TE05, (D) TE21, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?
A.	TE₀₁ [Correct Answer]
B.	TE₁₁ [Wrong Answer]
C.	TE₀₅ [Wrong Answer]
D.	TE₂₁ [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ The input impedance of op-amp circuit of figur
120 k ohm
110 k ohm
infinity
10 k ohm

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ RS latch can be built with
NOR gates
NAND gates
NOR or NAND gates
none of the above

⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
becomes zero
abruptly decrease
abruptly increases
remains constant

⇒ CATV stands for
Common Antenna Television
Community Antenna Television
Cable Antenna Television
Channel Antenna Television

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ For a class B amplifier using a supply of V_CC = 30 V and driving a load of 16 Ω the maximum efficiency will be __________ .
0.724
0.7854
0.624
0.6854

⇒ A conductor in x-y plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m² is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these

⇒ The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts
23.7 mA
14.2 mA
13.7 mA
24.2 mA

⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has a directivity of 100 is __________ .
15.92
31.84
3.184
1.592

⇒ In which of the following 8085 instructions are all condition flags except CY affected?
INR r
SEE M
ACI data
ADC r

⇒ A sinusoidal voltage amplitude modulates a carrier of peak value 5 kV. Each side band has an amplitude of 500 V. The modulation index is
0.1
0.2
0.4
0.8

⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
current, voltage
current, current
voltage, current
voltage, voltage

⇒ MOSFET can be used as a
current controlled capacitor
voltage controlled capacitor
current controlled inductor
voltage controlled inductor

⇒ The probability giving distribution of electrons over a range of allowed energy levels is known as
Maxwell's Distribution
Fermi-Dirac Distribution
Richardson Dushman Distribution
none of the above

⇒

Match the following:

	List I		List II
A.	IF noise	1.	Ganged tuning
B.	Image frequency	2.	Spurious response
C.	Station selector	3.	Leaky filter capacitor
D.	Excessive Hum	4.	Mixer stage

A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3

⇒ For frequencies upto 1650 kHz __________ antenna is used
yagi
grounded
turnstile
marconi

⇒ Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)
39 - 28 μsec
2.28 μsec
0.228 μsec
39.28 μsec

⇒

Match the following:

	List I		List II
A.	Reactance theorem	1.	Foster
B.	Driving point impedance	2.	Bartlett
C.	Continued fraction expansion	3.	Cauer
D.	Bisection Theorem	4.	Positive real function

A-1, B-4, C-3, D-2
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ The maximum range of a transmitter depends on
its frequency
its power
both its frequency and power
none of the above

⇒ In a JFET, the drain current is maximum when
V_GS = V_DS
V_GS = pinch off voltage
V_GS = 0
V_GS is negative

⇒ One of the following can be used to generate a pulse whenever triggered
flip-flop
monostable multivibrator
stable multivibrator
Schmitt trigger

⇒ Above ferroelectric curie temperature, spontaneous polarization in ferroelectric materials becomes stronger.
TRUE
FALSE

⇒ Nichols chart consists of M and N locii in log magnitude versus phase diagram.
TRUE
FALSE

⇒ The output of the circuit shown below will be of the frequ
125 Hz
250 Hz
500 Hz
750 Hz

⇒ Which of the following antenna is best guided by a waveguide?
Biconical
Horn
Helical
Dish