Question is ⇒ In which function is each term known as minterm?, Options are ⇒ (A) SOP, (B) POS, (C) Hybrid, (D) Both SOP and POS, (E) , Leave your comments or Download question paper.

Question is ⇒ In which function is each term known as minterm?, Options are ⇒ (A) SOP, (B) POS, (C) Hybrid, (D) Both SOP and POS, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which function is each term known as minterm?
A.	SOP [Correct Answer]
B.	POS [Wrong Answer]
C.	Hybrid [Wrong Answer]
D.	Both SOP and POS [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude
will increase
will decrease
will remain constant
will reduce to negligible value

⇒ In single phase half wave regulator, the average current over one full cycle
is always positive
may be positive or negative
may be negative
is always negative

⇒ Which of the following terms are applicable to troposcatter propagation?
Faradays rotation
SIOs
Fading
Atmospheric storms

⇒

Assertion (A): A TRIAC is a bidirectional SCR.

Reason (R): A TRIAC is a four layers 3 terminal device and can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The amount of photoelectric emission current depends on
frequency of incident radiation
intensity of incident radiation
both frequency and intensity of incident radiation
none of the above

⇒ Which of the following material can be used in cable shields?
Copper
Aluminium
Cast iron
Lead

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ The transconductance curve of a JFET is
a straight line
parabolic
hyperbolic
inverted V-type

⇒ A second-order band-pass active filter can be obtained by cascading a low pass second order section having cut off frequency f_OH with a high pass second order section having cut-off frequency f_OL provided
f_OH > f_OL
f_OH < f_OL
f_OH = f_OL
f_OH ≤ 1/2f_OL

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ A land line telemetry system is suitable for distance upto
about 1 km only
about 10 km only
about 100 km only
any of the above

⇒ Which of the following can provide two or more voice circuits with the same carrier?
SSB
Carrier reinsertion
Lincompex
Independent side band system

⇒

Assertion (A): Nyquist stability criterion uses the number of encirclements around (-1 + j0) point in GH plane to determine stability

Reason (R): The (-1 + j0) point in the s plane lies in the Nyquist path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In the circuit shown in the given figure, R_L will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω

⇒ 100101₂ is equal to decimal number
47
37
21
17

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET

⇒ Which of the following modes can exist in a rectangular waveguide?
TM₁₀
TE₁₀
TM₀₀
TM₀₁

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram
TRUE
FALSE

⇒ Consider the following statements

ECL has least propagation delay
TTL has largest fan out
CMOS has highest noise margin
TTL has lowest power dissipation

Which of these are correct?
1 and 3
2 and 4
3 and 4
1 and 2

⇒ Radio broadcasting is a familiar example of
space multiplexing
time multiplexing
frequency multiplexing
none of the above

⇒ The difference between phase and frequency modulation
is purely of academic interest
lies in the different definitions of the modulation index
lies in the poor audio response of phase modulation
is too great to make the two systems compatible

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above

⇒ If the value of C₂ and C₃ are doubled, the oscillation frequency will be
quadrupled
doubled
unchanged
halved

⇒ The sum of two sine waves of different frequencies is a sine wave.
TRUE
FALSE

⇒

Assertion (A): For the function shown in fi
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If F_n represents Fourier series coefficient of f(t), then Fourier series coefficient of f(t + t) =
F_ne ^-jω₀^t
F_ne ^jω₀^t
F_ne ^jnω₀^t
F_ne ^-jnω₀^t