Question is ⇒ In which frequency range is the noise figure in a transistor minimum, Options are ⇒ (A) intermediate frequencies, (B) low frequencies, (C) high frequencies, (D) very high frequencies, (E) , Leave your comments or Download question paper.

Question is ⇒ In which frequency range is the noise figure in a transistor minimum, Options are ⇒ (A) intermediate frequencies, (B) low frequencies, (C) high frequencies, (D) very high frequencies, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which frequency range is the noise figure in a transistor minimum
A.	intermediate frequencies [Correct Answer]
B.	low frequencies [Wrong Answer]
C.	high frequencies [Wrong Answer]
D.	very high frequencies [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ The dynamometer principle can be used for
ammeter only
voltmeter only
wattmeter only
ammeter, voltmeter and wattmeter

⇒

Assertion (A): In direct addressing the address of operand is specified in the instruction.

Reason (R): Direct addressing is also called absolute addressing.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Highest resistivity of the following is
nichrome
constantan
metal
manganin

⇒ FF₁₆ when converted to 8421BCD =
0000 0101 0101
0010 0101 0101
1111 0101 0101
1000 0101 0101

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒ The number of p-n junctions in a semiconductor diode are
0
1
2
1 or 2

⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
1.39 V
0.75 V
13.9 V
7.45 V

⇒ A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as
6000 bits/sec
4500 bits/sec
3000 bits/sec
1500 bits/sec

⇒ The inverse of given Laplace transfor
sin t
cos t
e^t
e^2t

⇒ Poynting vector signifies which of the following?
Power density vector producing electrostatic field
Power density vector producing electromagnetic field
Current density vector producing electrostatic field
Current density vector producing electromagnetic field

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒ The ratio of active power to apparent power is known as __________ factor.
power
load
form
demand

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ When a communication satellite passes into Earth's shadow, its temperature drops to about __________ ° K.
273
243
170
123

⇒ A black box has one of the elements our of R, L, C. when a 220 V a supply is connected the current supplied by source is I. when a 0.1 F capacitor is connected in parallel with the box, the current is 2I. The element is
resistance
inductance
0.1 F capacitance
not identifiable on the basis of given data

⇒ The compensator in the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above

⇒ Which of the following are true for relative dielectric constant?

It is dimensionless.
It is equal to 1 for vacuum.
It is equal to 1 for all substances.

1 and 2 only
2 and 3 only
1 and 3 only
1, 2 and 3

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ Which one is a non-causal system?
y(n) = x(2n)
y(n) = x(n/2)
y(n) = x(n/2) + x(n)
all

⇒ If a wave is propagated in free space, it will be in nature of
TE
TM
TEM
Any one of above

⇒ The impulse response of the DT - LTI system is given be
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ In major diatonic musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ Which of the following are useful in comparing the noise performance of receivers?

Input noise voltage
Noise figure
Noise resistance
Noise temperature

Select answer as per the following codes:
1, 2 and 3
1, 3 and 4
2, 3, 4
1, 2, 4

⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt² is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2

⇒ The output of a diode detector contains
D.C. voltage
modulating signal
RF ripple
all of the above

⇒ Refraction of electromagnetic waves occurs when they
pass through a small slot in a conducting plane
pass into a medium of different dielectric constant
are polarized at right angles to the direction of propagation
encounter a perfectly conduction surface

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less

⇒ One T state is precisely equal to one clock period.
TRUE
FALSE

⇒ What are the counting stages (Q₁, Q₂) for the counter shown in the figure be
11, 10, 00, 11, 10, ...
01, 10, 11, 00, 10, ...
00, 11, 01, 10, 00, ...
01, 10, 00, 01, 10, ...