Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
In which configuration does output ac voltage appear between emitter and ground? | |
A. | CE [Wrong Answer] |
B. | CB [Wrong Answer] |
C. | CC [Correct Answer] |
D. | Both CE and CB [Wrong Answer] |
View Answer
Explanation:-
Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top
⇒ If each frequency component of f(t) is shifted by p/2, the resulting signal is
Hilbert transform of f(t)
Inverse Hilbert transform of f(t)
Laplace transform of f(t)
Fourier transform of f(t)
⇒ The current in an RL series circuit is 1 - e^{-t} amperes. Then di/dt is
1 - e^{-t}
- e^{-t}
e^{t}
e^{-2t}
⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy
⇒ The compensator in the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above
⇒ In a conventional AM superhetrodyne receivers, the detectors employed to extract intelligence include
Peak detectors
Ratio detectors
PLL
Slope detectors
⇒ In calculating output impedance of an amplifier the source is replaced by an open circuit.
TRUE
FALSE
⇒ Loudness control gives
high boost to bass and little boost to treble
equal boost to bass and treble
less boost to bass and more boost to treble
less boost to both bass and treble
⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter
⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32
⇒ Values of V_{T} at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV
⇒ In a three cavity klystron amplifier, the oscillations are excited in
input cavity
output cavity
intermediate cavity
both (a) and (b)
⇒ The coil of a DArsonval galvanometer has N turns. If flux density is B, current is I and area of coil is A, the deflecting torque is
NBI/A
NBIA
NIA/B
N^{2}IAB
⇒ Which of the following is the least important consideration while selecting a logic technology?
Power dissipation
Noise immunity
Number of pins
Cost
⇒ The equivalent unit of joule is
newton
newton-meter
newton-metre^{2}
none of the above
⇒ In a series circuit with X_{L} constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE
⇒ The output v-i characteristics of enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value and a saturation region at high voltage
a saturation region at low voltage value and an ohmic region at high voltage
⇒ How many zone bits are th
2
4
8
16
⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely
⇒ The main advantage of hexadecimal numbers is
ease of conversion from hexadecimal to binary and vice-versa
ease of conversion from hexadecimal to decimal and vice-versa
ease of conversion from gray code to binary and vice-versa
the use of numbers and alphabets
⇒ Which language has a preprocessor?
Fortran 77
Pascal
C
None of the above
⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω
⇒ The advantage of transistor over vacuum tube is
no heat is required
small size and light in weight
very low power consumption
all of the above
⇒ A capacitor with initial charge q_{0} at t = 0^{+} acts as
current source
voltage source
short-circuit
open-circuit
⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance
⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec
⇒ When three 100 K, ± 10% fixed resistors of 1/4 W Power rating are connected in parallel, the resulting 33 K resistor will have a tolerance specification and power rating of
± 10% and 3/4 W respectively
± 10% and 1/12 W respectively
± 3.3.% and 3/4 W respectively
± 30% and 3/4 W respectively
⇒ A class E chopper
can operate in second quadrant only
can operate in first or third quadrant
can operate in all the four quadrants
can operate in either second or third quadrant
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true
⇒ For an I/p of V_{s} = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave
clipper, sine wave clipped at -2 V
clamper, sine wave clamped at -2 V
clamper, sine wave clamped at 0 volts
clipper, sine wave clipped at 2 V
⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top
⇒ If each frequency component of f(t) is shifted by p/2, the resulting signal is
Hilbert transform of f(t)
Inverse Hilbert transform of f(t)
Laplace transform of f(t)
Fourier transform of f(t)
⇒ The current in an RL series circuit is 1 - e^{-t} amperes. Then di/dt is
1 - e^{-t}
- e^{-t}
e^{t}
e^{-2t}
⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy
⇒ The compensator in the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above
⇒ In a conventional AM superhetrodyne receivers, the detectors employed to extract intelligence include
Peak detectors
Ratio detectors
PLL
Slope detectors
⇒ In calculating output impedance of an amplifier the source is replaced by an open circuit.
TRUE
FALSE
⇒ Loudness control gives
high boost to bass and little boost to treble
equal boost to bass and treble
less boost to bass and more boost to treble
less boost to both bass and treble
⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter
⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32
⇒ Values of V_{T} at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV
⇒ In a three cavity klystron amplifier, the oscillations are excited in
input cavity
output cavity
intermediate cavity
both (a) and (b)
⇒ The coil of a DArsonval galvanometer has N turns. If flux density is B, current is I and area of coil is A, the deflecting torque is
NBI/A
NBIA
NIA/B
N^{2}IAB
⇒ Which of the following is the least important consideration while selecting a logic technology?
Power dissipation
Noise immunity
Number of pins
Cost
⇒ The equivalent unit of joule is
newton
newton-meter
newton-metre^{2}
none of the above
⇒ In a series circuit with X_{L} constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE
⇒ The output v-i characteristics of enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value and a saturation region at high voltage
a saturation region at low voltage value and an ohmic region at high voltage
⇒ How many zone bits are th
2
4
8
16
⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely
⇒ The main advantage of hexadecimal numbers is
ease of conversion from hexadecimal to binary and vice-versa
ease of conversion from hexadecimal to decimal and vice-versa
ease of conversion from gray code to binary and vice-versa
the use of numbers and alphabets
⇒ Which language has a preprocessor?
Fortran 77
Pascal
C
None of the above
⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω
⇒ The advantage of transistor over vacuum tube is
no heat is required
small size and light in weight
very low power consumption
all of the above
⇒ A capacitor with initial charge q_{0} at t = 0^{+} acts as
current source
voltage source
short-circuit
open-circuit
⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance
⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec
⇒ When three 100 K, ± 10% fixed resistors of 1/4 W Power rating are connected in parallel, the resulting 33 K resistor will have a tolerance specification and power rating of
± 10% and 3/4 W respectively
± 10% and 1/12 W respectively
± 3.3.% and 3/4 W respectively
± 30% and 3/4 W respectively
⇒ A class E chopper
can operate in second quadrant only
can operate in first or third quadrant
can operate in all the four quadrants
can operate in either second or third quadrant
⇒
Assertion (A): In totem pole output the output impedance is low.
Reason (R): TTL gate with active pull up should not be used in wired AND connection.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true
⇒ For an I/p of V_{s} = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave
clipper, sine wave clipped at -2 V
clamper, sine wave clamped at -2 V
clamper, sine wave clamped at 0 volts
clipper, sine wave clipped at 2 V