Question is ⇒ In using Nyquist stability criterion it is not necessary to determine closed loop poles., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In using Nyquist stability criterion it is not necessary to determine closed loop poles., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In using Nyquist stability criterion it is not necessary to determine closed loop poles.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. when the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒ Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is
1.67
0.6
0.36
0.216

⇒ Consider the following statemen
1, 2, 3, 4
1, 2, 3
1, 2
1, 3, 4

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :
62831.9 V/sec
125663.8 V/sec
31415.95 V/sec
None

⇒ If a signal f(t/2) has energy is E/n then energy of the signal f(nt) is equal to __________ (n is constant)
E/2n²
2E/n²
E/n²
2En²

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
20 ∠20° A
10 ∠20° A
14.14 ∠20° A
10 ∠- 20° A

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ The poles and zeros of a positive real functions are real or occur in conjugate pair.
TRUE
FALSE

⇒ The main feature of a parametric amplifier is
low noise
very high gain
broad bandwidth
both (b) and (c)

⇒ The dc voltage on plate modulated class C amplifier is 8 kV. If the peak modulating voltage is 4 kV, the peak RF voltage delivered to load is
32 kV
12 kV
0.5 kV
24 kV

⇒ A phasor is
a line representing the magnitude and direction of an alternating quantity
a line which represents the magnitude and phase of an alternating quantity
an instrument used for measuring phases of an unbalanced 3-phase load
a coloured tag or band for distinguishing between different phases of a 3-phase supply

⇒ Consider the following statements: The radar pulse must be flat topped to

allow accurate range measurement
allow good minimum range
prevent frequency changes in magnetron
make the returned echoes easier to distinguish from noise.

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
1, 2
1, 3, 4

⇒ Whenever a JFET operates above pinch-off voltage
depletion regions become smaller
drain current increase steeply
drain current starts decreasing
drain current remains nearly constant

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes

⇒ An ideal op-amp requires
zero input offset voltage
low input offset voltage
high input offset voltage
infinite input offset voltage

⇒

Assertion (A): Microprocessor 8085 can address 65536 memory locations.

Reason (R): Microprocessor 8085 has 16 address lines.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The amplitude of a modulated RF aerial current is 6 A on the peaks of modulation and 4 A on the troughs of modulation. The value of carrier amplitude is
5
15
20
30

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ Consider the following statements:

If any root of characteristic equation has a positive real part the impulse response is unbounded and system is unstable.
If all the roots of a characteristic equation have negative real parts, the impulse response decays to zero.
If one or more non-repeated roots of characteristic equation are on jω axis impulse response is bounded but the system is unstable.

Which of the above equations are correct?
1, 2 and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Push pull amplifier is
voltage amplifier
current amplifier
power amplifier
none of the above

⇒ Which statement is incorrect for the signal x(t) = 5 sin (2p x 10³t) sin (2p x 10⁶t)?
Upper side band frequency is 1001000
Carrier amplitude is 5
Lower sideband frequency is 990000
x(t) is DSB-SC

⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ The main advantage of superheterodyne receiver is
better tracking
simple cut
better alignment
improvement in selectivity and sensitivity

⇒ Use of high permeability core in moving iron instrument helps in
reducing size of meter
increasing sensitivity
reducing temperature error
all of the above

⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these

⇒ Which one of the following is the correct sequence of the numbers represented in the series given below?
2, 3, 4, 5, 6......
2, 4, 6, 8, 10 .....
2, 4, 6, 10, 12......
2, 4, 6, 10, 16 .....

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ When a ferromagnetic substance is magnetised there are small changes in dimensions. This phenomenon is called
hysteresis
magnetostriction
diamagnetism
dipolar relaxation