Question is ⇒ In the two ports network shown in the figure, Z12 and Z21 are, respecti, Options are ⇒ (A) re and βr0, (B) 0 and - βr0, (C) 0 and βr0, (D) re and - βr0, (E) , Leave your comments or Download question paper.

Question is ⇒ In the two ports network shown in the figure, Z12 and Z21 are, respecti, Options are ⇒ (A) re and βr0, (B) 0 and - βr0, (C) 0 and βr0, (D) re and - βr0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the two ports network shown in the figure, Z₁₂ and Z₂₁ are, respecti
A.	r_e and βr₀ [Wrong Answer]
B.	0 and - βr₀ [Correct Answer]
C.	0 and βr₀ [Wrong Answer]
D.	r_e and - βr₀ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 3 phase star-connected load has one capacitor C in R phase and two equal resistances in Y and B phases.The phase sequence is RBY. Then
V_B0 > V_Y0
V_B0 < V_Y0
V_B0 = V_Y0
V_B0 = V_BY

⇒ The overall noise temperature T_e, absolute temperature T and noise figure F are related as
T_e = T(F - 1)
T_e = F(T - 1)
T = T_e(F - 1)
T_e = (T)(F)

⇒ The input and output of a continuous time system are respectively denoted by x(t) and y(t) Which of the following descriptions corresponds to a causal system?
y(t) = x(t - 2) + x(t + 4)
y(t) = x(t - 4) + x(t + 1)
y(t) = x(t + 4) + x(t - 1)
y(t) = x(t + 5) + x(t + 5)

⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be
111 V
100 V
90.9 V
70.7 V

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ The effect of adding poles and zeros can be determined quickly by
Nichols chart
Nyquist plot
Bode plot
Root locus

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.

Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which camera tube has highest dark current?
Plumbicon
Vidicon
Saticon
GCD imager

⇒ A diode can have a very high forward resistance.
TRUE
FALSE

⇒ The time constant of a series RL circuit is
LR
L/R
R/L
e^-R/L

⇒ If sequence currents I_a1 = 2 ∠- 90°, I_a2 = 0.2 ∠ 90° and I_a3 = 1.8 ∠ 90°, I_a =
0
1
4
8

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒

Assertion (A): If source and destination addresses are made implicit the length of instruction is reduced.

Reason (R): 8085 has only 3 addressing modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): When V_DS is more than rated value the drain current in a JFET is very high.

Reason (R): When V_DS is more than rated value, avalanche breakdown occurs.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ ∇² is
vector
scalar
depend on direction
none

⇒ Entropies associated with an extremely unlikely message and that with an extremely likely message are respectively
0 and 0
1 and 1
1 and 0
0 and 1

⇒ The function in the given figure can be writte
u(t - 1) sin p ( t - 1) - u(t - 3) sin p (t - 3) + u(t - 4) sin p (t - 4) - u(t - 6) sin p (t - 6)
u(t - 1) sin p ( t - 1) - u(t - 3) sin p (t - 3) + u(t - 4) sin p (t - 4)
u(t - 1) sin p ( t - 1) + u(t - 4) sin p (t - 4)
u(t - 1) sin 2p ( t - 1) + u(t - 4) sin 2p (t - 4)

⇒ The reflection coefficient on a 500 m long transmission line has a phase angle of - 150°. If the operating wavelength is 150 m, what will be the number of voltage maxima on the line?
0
3
6
7

⇒ 100101.1011₂ = __________ .
115.22₈
115.54₈
215.54₈
100.01₈

⇒ For a level input sequential circuit
output in a level only
output is in the pulse form
output may be a pulse or a level form
none of these

⇒ If noise margin is high, there is lesser chance of false operation.
TRUE
FALSE

⇒ Fields are said to be circularly polarised if their magnitudes are
equal and they are in phase
equal but they differ in phase by ± 90°
unequal and differ in phase by ± 90°
unequal but are in phase

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ In a AM wave the carrier and one of the side bands is suppressed. If m = 0.5, the percentage saving in power is
0.5
0.833
0.944
1

⇒ A 'rat race' is a
hybrid junction for microwaves
a microwave oscillator
a microwave amplifier
a microwave antenna

⇒ In common base connection, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_C and V_CE
I_E and V_CB
I_E and V_CE

⇒ For a Gaussian process, auto-correlation sequence also implies that
statistical independence
statistical dependence
ergodic process
all

⇒ A capacitor whose capacitance C_t = C₀ (1- cos ωt) is fed by a sinusoidal voltage v = V₀ sin ωt. The equation for current i is
ω C₀V₀ cos ωt
ω C₀V₀ sin ωt
ω C₀V₀ (cos ωt - cos² ωt)
none of the above

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode