Question is ⇒ In the self biasing scheme (RF across collector to base) of BJT, S1 tends to unity by __________ RC is the collector load Resistance., Options are ⇒ (A) increasing RF, (B) decreasing RF, (C) decreasing RF and increasing RC, (D) increasing RF and decreasing RC, (E) , Leave your comments or Download question paper.

Question is ⇒ In the self biasing scheme (RF across collector to base) of BJT, S1 tends to unity by __________ RC is the collector load Resistance., Options are ⇒ (A) increasing RF, (B) decreasing RF, (C) decreasing RF and increasing RC, (D) increasing RF and decreasing RC, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the self biasing scheme (R_F across collector to base) of BJT, S₁ tends to unity by __________ R_C is the collector load Resistance.
A.	increasing R_F [Wrong Answer]
B.	decreasing R_F [Wrong Answer]
C.	decreasing R_F and increasing R_C [Correct Answer]
D.	increasing R_F and decreasing R_C [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In home tape recorders the tape width is 2 inches.
TRUE
FALSE

⇒ In 8086 the word address is
the address of the least significant byte
the address of most significant byte
either (a) or (b) depending on the word
neither (a) nor (b)

⇒ In a network containing resistances, reactances the root of the characteristic equation give for the circuit
the forced response
the total response
the natural response
the damped response

⇒ In a single phase full wave ac regulator the firing angles during both half cycles are equal.
TRUE
FALSE

⇒ Which of the following represents constant magnitude locus for M = 1?
x = -0.5
x = 0
x² + y² = 1
(x + 1)² + y² = 1

⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
1.6 dB
2 dB
3.6 dB
6 dB

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An ac wave with superimposed dc is symmetrical about x - axis.
TRUE
FALSE

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register D are stored
054 CH
054 DH
054 EH
054 FH

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ For a full rectified sine wave, the form factor and peak factor respectively are
1.57 and 2
1.57 and 2
1.11 and 1.11
1.11 and 2

⇒ How many lines are there in address bus of 8085 μp?
6
8
12
16

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒ The oscillator frequency is set for
best picture
max. sound
min. sound
sound in picture

⇒

Assertion (A): An ac regulator uses natural commutation

Reason (R): An ac regulator can be used for static on load tap changing of transformer.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When a diode is forward biased, the diode current is
high
low
zero
low or zero

⇒ The number of bits in ASCII is
12
10
9
7

⇒

Assertion (A): PIN diode is commonly used for microwave control.

Reason (R): A PIN diode uses heavily doped p and n materials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒

Assertion (A): In reverse biased p-n junction, the reverse saturation current is nearly constant if the reverse voltage is less than critical value.

Reason (R): The total reverse current is sum of reverse saturation current and surface leakage current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ Which one is not a valid subscripted variable?
KET(2^* J, 3^* 1 - 4)
MET(J + 2, K - 4)
A (2 I)
VEL(I)

⇒ The resolution of a 12-bit D/A converter using a binary ladder with + 10V as the full scale output will be
2.44 mV
3.50 mV
4.32 mV
5.12 mV

⇒ A line of characteristic impedance 400 Ω is terminated by a resistance of 400 Ω. The reflected quantities are
zero
equal to incident quantities
half the incident quantities
double the incident quantities

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒ The approximate value of input impedance of CE amplifier with emitter resistance R_E is given by
h_ie + A_i R_E
h_ie + (1 + h_fe) R_E
h_ie
(1 + h_fe) R_E

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be
horizontally polarized
vertically polarized
at 45° within respect to horizontal polarization
at 45° with respect to vertical polarization