Question is ⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called, Options are ⇒ (A) saturation point, (B) cut off point, (C) Q point, (D) operating point, (E) , Leave your comments or Download question paper.

Question is ⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called, Options are ⇒ (A) saturation point, (B) cut off point, (C) Q point, (D) operating point, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
A.	saturation point [Wrong Answer]
B.	cut off point [Wrong Answer]
C.	Q point [Correct Answer]
D.	operating point [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The orientation polarization of a polyatomic gas is inversely proportional to absolute temperature.
TRUE
FALSE

⇒ If x₁(t) = 2 sin pt + cos 4 pt and x₂(t) = sin 5 pt + 3 sin 13 pt then
x₁, x₂ both periodic
x₁ x₂ both not periodic
x₁ periodic, x₂ not periodic
x₁ is not periodic ; but x₂ is periodic

⇒ An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is
105
95
85
75

⇒ The speeds used in recording audio programs in house hold recorders are
38 cm/s and 9.5 cm/s
38 cm/s and 19 cm/s
9.5 cm/s and 4.75 cm/s
38 cm/s and 4.75 cm/s

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒

Assertion (A): The horizontal intercept of dc load line is the same as ideal cut off point

Reason (R): When a transistor is in cut off region, collector current is zero

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ For use at 50 Hz the range of scale of vibrating reed frequency meter is
25 - 75 Hz
40 - 60 Hz
47 - 53 Hz
42 - 58 Hz

⇒ Laplacian of a scalar function V is
gradient of V
gradient of the gradient of V
divergence of V
divergence of the gradient of V

⇒ Fourier transform of f(t) =
jω F(f)
2pf F(f)
F'(f)
None

⇒ Which of the following is necessary transistor action?
The base region must be very wide
The base region must be very narrow
The base region must be made of some insulating material
The collector region must be heavily doped

⇒ The instruction MOV M, r in 8085
causes content of register r to be moved to memory location whose address is in register H, L and uses register indirect addressing mode
causes the content of memory location whose address is in register H, L to move to register r and uses register indirect addressing mode
causes the content of register r to be moved to memory location whose address is in register H, L and uses immediate addressing mode
causes the content of memory location whose address is in register H, L to move to register r and uses immediate addressing mode

⇒ If e = 110 sin (ωt + p/3) and i = 5 sin (ωt - p/3), the impedance of the circuit is
22 Ω
16 Ω
30.8 Ω
11 Ω

⇒ In the given circuit, V₁ = 40 V when R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒ Which are the pending interrupts?
5.5
6.5
7.5
None

⇒ In dc tacho generators used for measurement of speed of shaft, frequent calibration is necessary because
contacts wear off
strength of permanent magnet decreases with age
armature current produces heating effect
there is back emf

⇒ Frequency domain of a periodic triangular function is a
discrete sinc function
continuous sampling function
discrete sampling function
continuous sampling square function

⇒ A meter has a resistance of 1 Ω and full scale deflection current of 1 mA. To convert into an ammeter of 1 A range, the shunt resistance should be
1000 Ω
1 Ω
0.01 Ω
0.001 Ω

⇒ In a single phase full wave ac regulator, the firing angles in the two half cycles
are always equal
are sometimes equal
are never equal
may be equal or unequal

⇒ A two port network is symmetrical if
z₁₁ z₁₂ - z₁₂ z₂₁ = 1
AD - BC = 1
h₁₁ h₂₂ - h₁₂ h₄₁ = 1
y₁₁ y₂₂ = y₁₂ y₂₁ = 1

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒ As the atoms of rare gases become larger, electronic polarizability
increases
decreases
remains the same
may increase or decrease

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ A presettable counter with 4 flip flops can start counting from
0
1000
any number from 0000 to 1000
any number from 0000 to 1111

⇒ In a cellular communication system, path loss between transmitter and receiver is due to
scattering from building, trees, vehicles and other structure
reason at (a) above and due to reflections from ground only
reason at (a) and (b) above along with reflections from ionosphere only
reasons at (a), (b) and (c) above along with loss due to surface wave phenomenon

⇒ In the network of figure, the voltage drops across R₁, R₂, R₃ are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω
8 Ω
5 Ω
3 Ω}

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒

Assertion (A): A RAM with access time of the order of hundreds of nano seconds is suitable for a control memory.

Reason (R): The time taken to execute an operation in a microcomputer is critically de pendent on access time of control memory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In an op-amp comparator, the positive or negative output is
saturated
amplifier
unsaturated
any of the above

⇒ A transmitter radiates a power 20 KW and its base current is 18A. The radiation resistance of the antenna is
1111 Ω
900 Ω
75 Ω
62 Ω