Question is ⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil, Options are ⇒ (A) 0, (B) 101, (C) 1010, (D) 1111, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil, Options are ⇒ (A) 0, (B) 101, (C) 1010, (D) 1111, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil
A.	0 [Wrong Answer]
B.	101 [Wrong Answer]
C.	1010 [Correct Answer]
D.	1111 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ In a 3 phase semiconverter, the firing frequency is
equal to line frequency
3 times the line frequency
6 times the line frequency
12 times the line frequency

⇒

Assertion (A): Power is the rate at which energy is supplied.

Reason (R): Energy = VIt.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒ Which of the following memory is preferred in case of calculators?
Dynamic RAM
Dynamic ROM
Static ROM
Static RAM

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ A signal is sampled at Nyquist rate f_s = 2f₀. The function can be recovered from its samples only. If it is a
Periodic square wave of fundamental frequency f₀
Triangular wave of fundamental frequency f₀
Periodic sine wave of fundamental frequency f₀
Unit impulse function

⇒ The depletion layer in a reverse biased p-n junction is due to the presence of
electrons
holes
both electrons and holes
immobile ions

⇒ In the amplifier circuit of figure h_fe = 100 and h_ie = 1000 Ω. The voltage gain of amplifier is a
0.33
0.5
0.66
1

⇒ Boolean expression for the output of XNOR (Equivalent) logic gate with inputs A and B is
AB + AB
AB + AB
(A + B). (A + B)
(A + B). (A + B)

⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement 13
16
9
14

⇒ Thyristors connected in series need :
static equalizing circuit
dynamic equalizing circuit
both static and dynamic equalizing circuits
none of the above

⇒

Assertion (A): Oxide coated cathodes are very commonly used.

Reason (R): Work function of oxide coated cathode is 1 eV whereas it is 4.5 eV for pure tungsten.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The response to sinusoidal excitation can be found by
settings s = jω in the network function
settings s = - jω in the network function
taking inverse transform of network function
none of the above

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒ A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
220 V
200 V
198 V
0 volts

⇒ V-I relationship of a network N is given by, V = 8 -
0, 2
0, 4
2, 4
None of these

⇒ The circuit of the given figure perf
OR function
AND function
exclusive OR function
exclusive NOR function

⇒ For an op-amp source follower circuit
input and output voltages have same magnitude
output and input voltages are in phase
output and input voltages are in phase but have different magnitudes
output and input voltages have same magnitude and are in phase

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The voltage multiplication is
25
50
125
250

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ Consider the following logical IF statement in Fortran 77 IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 13, 11, 11
IF (SALT - PEPPER) 13, 13, 11
IF (SALT - PEPPER) 11, 13, 13

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒ The effective length of antenna is different from actual length due to
top loading
end effects
both (a) and (b)
none of the above

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ The Boolean expression Y = (A + B + AB) C then Y will be equal to
AC
BC
C
none

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒

Assertion (A): Each memory chip has its own address latch.

Reason (R): ALE signal comes out of microprocessor 8085 and goes to memory chip.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above