Question is ⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul, Options are ⇒ (A) A = 1, B = 1, C = 1, (B) A = 1, B = 1, C = 0, (C) A = 0, B = 1, C = 1, (D) A = 0, B = 0, C = 1, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul, Options are ⇒ (A) A = 1, B = 1, C = 1, (B) A = 1, B = 1, C = 0, (C) A = 0, B = 1, C = 1, (D) A = 0, B = 0, C = 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A.	A = 1, B = 1, C = 1 [Correct Answer]
B.	A = 1, B = 1, C = 0 [Wrong Answer]
C.	A = 0, B = 1, C = 1 [Wrong Answer]
D.	A = 0, B = 0, C = 1 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In orthogonal BFSK, the energy of information bearing term is
the same as total transmitted energy
one-half of total transmitted energy
one-fourth of total transmitted energy
none of the above

⇒ For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
PQ + PQ S + Q R S
P Q + PQ R + P Q S
P Q R + P QR + PQRS + Q R S
PQ R + PQR S + P Q R S + Q R S

⇒ If a resistance R of 1 Ω is connected between A and B in figure, current flowing through
0.0416666666666667
0.5 A
0.25 A
0.125 A

⇒ Laplace transform method enables us to find the response in
steady state
transient state
both steady and transient state
transient state provided forcing functions do not exist

⇒ The shunt admittance of a transmission line is given by
γ = R + jωL
γ = R - jωL
γ = G + jωC
γ = jωGC

⇒ What are the contents of the accumulator after the RIC has been executed?
40 H
41 H
42 H
43 D

⇒

Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing.

Reason (R): During turn on the reverse biased junction in SCR breaksdown.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a CE amplifier, the output voltage is equal to product of
ac collector current and ac collector resistance
ac base current and ac collector resistance
ac emitter current and ac emitter resistance
ac collector current and source resistance

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒ In a zener diode
forward voltage rating is high
negative resistance characteristics exists
sharp breakdown occurs at low reverse voltage
none of the above

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ The ROC of sequence in the Z.T. of sequence x[n] = aⁿ ∪ [n] is
z > a
z < a
|z| > a
|z| < a

⇒ An one sided abrupt junction has 10²¹/m³ of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^-19 C, ε_r =16, ε₀ = 8.87 x 10^-12 F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm

⇒ Which of the following quantities cannot be measured/determined using Hall effect?
Type of semiconductor (p or n)
Mobility of charge carriers
Diffusion constant
Carrier concentration

⇒

Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ T- FF used as a
transfer Data switch
toggle switch
time delay switch
none

⇒ The highest modulating frequency typically used in AM systems is
1 kHz
5 kHz
20 kHz
50 kHz

⇒ A certain JK FF has t_pd = 12 n sec the largest MOD counter that can be constructed from these FF and still operate up to 10 MHz is
any
8
256
10

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ In a radio receiver the input from local oscillator is fed to
RF amplifier
mixer
IF amplifier
detector

⇒ Consider the following statements about Rhombic antenna

It is non resonant
It is a broad band antenna
It is ideally suited for HF transmission

Which of the above are correct?
1, 2, 3
1, 3 only
2, 3 only
1 only

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ If the time is counted from the instant when an ac wave is at its peak value, we get a
sine wave
cosine wave
distorted sine wave
none of the above

⇒

Assertion (A): In monolithic IC the components are part of one chip

Reason (R): An op-amp is a high gain dc amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A coil of resistance R and inductance L is connected in series with 10 mF capacitor. The resonant frequency is 1000 Hz. Another 10 F capacitor is connected in parallel with the above capacitor. The new resonance frequency will be
1000 Hz
more than 1000 Hz
less than 1000 Hz
may be more or less than 10000 Hz

⇒ A 120 V, 30 Hz source feeds a half wave rectifier circuit through a 4 : 1 step down transformer, the average output voltage is
30 V
13.5 V
10 V
7.07 V

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ Terra-watt is equal to
10³ W
10⁶ W
10⁹ W
10¹² W

⇒ Which of the following circuit has the greatest bandwidth?
f_r = 455 MHz; Q = 10
f_r = 455 MHz; Q = 100
f_r = 1 MHz; Q = 100
f_r = 1 MHz; Q = 10