Question is ⇒ In the given figure forward current wave has a magnitud, Options are ⇒ (A) 0.45 A, (B) 0.3 A, (C) 0.2 A, (D) 0.1 A, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure forward current wave has a magnitud, Options are ⇒ (A) 0.45 A, (B) 0.3 A, (C) 0.2 A, (D) 0.1 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure forward current wave has a magnitud
A.	0.45 A [Wrong Answer]
B.	0.3 A [Correct Answer]
C.	0.2 A [Wrong Answer]
D.	0.1 A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The duty cycle of a radar transmitter is equal to
(PRF) (pulse width)
(PRF)/(pulse width)
(pulse width)/(PRF)
(pulse width) + (PRF)

⇒

Assertion (A): When a PID controller is added to a system, the peak overshoot to step input cannot be determined easily.

Reason (R): Use of PID controller introduces a zero in the forward path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If f is the frequency of electromagnetic wave, f_c is cutoff frequency, then in a rectangular waveguide
attenuation is low when f > f_c
attenuation is low when f < f_c
attenuation is high when f < f_c
either (b) or (c)

⇒ The assigned carrier frequency of an FM broadcast station is 96.3 MHz. Its FM signal has a centre frequency of
10 MHz
455 kHz
48.15 MHz
96.3 MHz

⇒ In narrowband FM, the modulation index is
near unity
about 100
about 0.1
about 300

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ In a CE bipolar transistor operating in active region, collector current is independent of
V_CE
I_B
both V_CE and I_B
none of the above

⇒ An op-amp uses
RC coupling
direct coupling
transformer coupling
either (b) or (c)

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ Which of the following flip-flops is used as latch?
JK flip-flop
D flip-flop
RS flip-flop
T flip-flop

⇒ In the given figure, the number of individual loop
2
4
5
6

⇒ The number of logic or arithmetic operations with ALU 1C 74181 can carry out is
4
8
16
32

⇒ In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is
150 A
75 A
50 A
300 A

⇒ Which of the following integer expressions is correct in Pascal?
- A + B + M
A div B * mod C
A - 4.0
A / B + D

⇒ In elemental dielectrics, the orientation and ionic polarization are absent.
TRUE
FALSE

⇒ What is the normal range of analog input voltage?
0 to 1 V
0 to 5 V
5 to 15 V
15V to 30V

⇒ The deflection sensitivity of a CRO is generally expressed in
meter/V
cm/V
V/meter
V/cm

⇒ In steady state condition inductor behave as
open circuit
short circuit
current source
voltage source

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
none

⇒ The drift velocity of electrons and holes is proportional to electric field strength.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Multiplexer	1.	Sequential memory
B.	De-multiplexer	2.	Converts decimal number to binary
C.	Shift register	3.	Data selector
D.	Encoder	4.	Routes single input to many outputs

A-3, B-4, C-1, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4

⇒ In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.
TRUE
FALSE

⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC

⇒ What does the instruction 'PCHL' in 8085 do?
Load the program counter with contents of register pair H L
Double the contents of register pair H L
Shift the contents of register pair H L by one bit to the right
Shift the contents of register pair H L by one bit to left

⇒ The expression Y (A, B, C) = ∑m (1, 3, 5, 6) is to realized using a multiplexer. Then
use 8 : 1 multiplexer and ground input lines 1, 3, 5, 6
use 8 : 1 multiplexer and ground input lines 0, 2, 4, 7
use 8 : 1 multiplexer and ground input lines 0, 1, 2, 3
use 8 : 1 multiplexer and ground input lines 4, 5, 6, 7

⇒ The household radio receiver uses
synchronous
envelope detector
radio detector
none of the above

⇒ For a full rectified sine wave, the form factor and peak factor respectively are
1.57 and 2
1.57 and 2
1.11 and 1.11
1.11 and 2