Question is ⇒ In the FM wave described by equation v = 15 sin (4 x 108 t + 3 sin 1100 t), the carrier frequency and signal frequency respectively are, Options are ⇒ (A) 63.66 MHz and 175 Hz, (B) 4 x 108 Hz and 1100 Hz, (C) 175 Hz and 63.66 MHz, (D) 1100 Hz and 4 x 108 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ In the FM wave described by equation v = 15 sin (4 x 108 t + 3 sin 1100 t), the carrier frequency and signal frequency respectively are, Options are ⇒ (A) 63.66 MHz and 175 Hz, (B) 4 x 108 Hz and 1100 Hz, (C) 175 Hz and 63.66 MHz, (D) 1100 Hz and 4 x 108 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the carrier frequency and signal frequency respectively are
A.	63.66 MHz and 175 Hz [Correct Answer]
B.	4 x 10⁸ Hz and 1100 Hz [Wrong Answer]
C.	175 Hz and 63.66 MHz [Wrong Answer]
D.	1100 Hz and 4 x 10⁸ Hz [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The contents of F register in 8085 are 01010001. This means
S = 0, Z = 1, AC = 1, P = 0 and CY=1
S = 1, Z = 1, AC = 1, P = 0 and CY=1
S = 1, Z = 0, AC = 1, P = 0 and CY=1
S = 1, Z = 0, AC = 0, P = 0 and CY=1

⇒ Consider the following statements

Gunn diode can be used in combinational logic circuits.
Gunn diode can be used in sequential logic circuits.
Both Gunn diode and GaAs Mesfet can be used in logic circuits.

Which of the above statements are correct?
1, 2, and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?
line open circuited at far end
line terminated in Z₀
line short circuited at far end
line terminated in inductance

⇒ Under ordinary circumstances, impulse noise can be reduced in
FM only
AM only
both AM and FM
none of the above

⇒ Circuit shown in the figur
astable multivibrator
monostable multivibrator
VCO
ramp Generator

⇒ At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves
open circuit
short circuit
pure resistor of value R
pure resistor of value much higher than R

⇒ Decimal 1932 when converted into 10's complement will become
8868
8060
8608
8806

⇒ As per temperature limits, the number of categories of solid dielectrics are
7
6
8
5

⇒ Consider the following statements about an array in Pascal

An array has a fixed predetermined number of components.
Any component of an array can be accessed using an index.
An array variable name refers to a group of quantities by a single name.
When array variables are used an appropriate declaration is required.

Which of the above are correct?
All
1, 2, 3 only
2, 3, 4 only
1, 2 and 4 only

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ In orthogonal BFSK, the energy of information bearing term is
the same as total transmitted energy
one-half of total transmitted energy
one-fourth of total transmitted energy
none of the above

⇒ Consider the CMOS circuit shown, where the gate voltage V_G of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC_0x(W/L), is 1mA. V^{-2Both the MOSFET are in saturation region
Both the MOSFET are in triode region
n-MOSFET is in triode and p-MOSFET is in saturation region
n-MOSFET is in saturation and p-MOSFET is in triode region}

⇒ Self impedance is
same for transmitting (T_t) and receiving antenna (T_r)
T_t > T_r
T_r > T_t
no relation

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The main reason why Ni-Zn ferrites are used for audio and T.V. transformers is that
they have large saturation magnetization
they are easy to fabricate by rolling
they are totally free from pores and voids
they have a high electrical resistivity

⇒ When the gate terminal of MOSFET is positive, it is said to operate in
depletion mode
conduction mode
enhancement mode
none of the above

⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to
increase its I_QL
reduce its I_0H
increase its speed of operation
reduce power dissipation

⇒ A system has its two poles on the negative real axis and one pair of poles lies on jω axis. The system is
stable
unstable
limitedly stable
either (a) or (c)

⇒ A compiler converts a high level computer program into machine language program.
TRUE
FALSE

⇒ A TV remote control works on the principle of
pulse code modulated ultra violet light
pulse code modulated infrared light
demodulation
either (a) or (b)

⇒ Audio systems use transverse recording.
TRUE
FALSE

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p

⇒ In the circuit shown in the given figure, R_L will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω

⇒ A 2 μF capacitor is shunted by a 1 kΩ maintained at temperature 400 K. The rms noise voltage across the capacitor over the entire frequency band is:
6.25 x 10^-8 V
5.25 x 10^-6 V
6.25 x 10^-6 V
5.25 x 10^-8 V

⇒ A 0-200 V voltmeter has an accuracy of 0.75% of full scale reading. If voltage measured is 100 V, the error is
0.03
0.02
0.015
0.0075

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ A 12 bit ADC is operating with 1 μs clock period. Total conversion time is 14 μs. ADC is
flash type
counting type
integrating type
successive approximation type

⇒ Noise which assumes great importance at high frequencies is
flicker noise
Johnson noise
transit-time noise
shot noise

⇒ The integral of a unit step function is
a unit impulse function
a unit pulse function
a ramp function of slope 1
none of the above