Question is ⇒ In the figure, the, Options are ⇒ (A) emits light when both S1 and S2 are closed, (B) emits light when both S1 and S2 are open, (C) emits light when only S1 and S2 is closed, (D) does not Emit light, irrespective of the switched positions, (E) , Leave your comments or Download question paper.

Question is ⇒ In the figure, the, Options are ⇒ (A) emits light when both S1 and S2 are closed, (B) emits light when both S1 and S2 are open, (C) emits light when only S1 and S2 is closed, (D) does not Emit light, irrespective of the switched positions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the figure, the
A.	emits light when both S₁ and S₂ are closed [Wrong Answer]
B.	emits light when both S₁ and S₂ are open [Wrong Answer]
C.	emits light when only S₁ and S₂ is closed [Wrong Answer]
D.	does not Emit light, irrespective of the switched positions [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Zip floppy has a capacity of
50 MB
500 MB
25 MB
100 MB or 250 MB

⇒ A material which is lightly repelled by a magnetic field is known as
diamagnetic material
non-magnetic material
ferromagnetic material
paramagnetic material

⇒ The effect of negative feedback on distortion and bandwidth because
both are decreased
both are increased
distortion is reduced and bandwidth is increased
distortion is increased and bandwidth is decreased

⇒ In the circuit of figure, the power consumed in resistance R is measured when one source is acting at one time. These values are 18 W, 50 W and 98 W. When all source act together the maximum and minimum power ca
98 W and 18 W
166 W and 18 W
450 W and 2 W
166 W and 2 W

⇒ Nichrome is used in
heater coils
underground cables
overheated wires
lamp filament

⇒ All network theorems of dc are applicable to ac also with different quantities taken as phasors.
TRUE
FALSE

⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage

⇒ In a piezoelectric crystal, the application of mechanical force will cause
plastic deformation of crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in Fermi level

⇒ A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.
0 Hz
0.75 kHz
0.5 kHz
0.25 kHz

⇒ In admittance parameter set, the dependent variables are the currents at the two ports.
TRUE
FALSE

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ A capacitor input filter relies on
average detection
peak detection
both (a) and (b)
neither (a) nor (b)

⇒ Which of the following is not correct?
Voltmeter should have a very high resistance
An ammeter should have a very low resistance
A shunt should have a very low resistance
An electronic voltmeter draws appreciable current from source

⇒ The complement of Boolean expression AB (B C + AC) is
(A + B) + (B + C) + (A + C)
A B + (B + C)(A + C)
(A + B) + (B + C) (A + C)
none of the above

⇒ At any point on the v-i characteristics of a semiconductor diode, the slope of v-i characteristics is called
resistance of diode
conductance of diode
incremental resistance of diode
incremental conductance of diode

⇒ A system is said to be static system, when present output depend upon
present I/P
presrent and past
present and future
past and future

⇒ MS Excel is an application software for financial planning.
TRUE
FALSE

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ Which of the following statements is incorrect?
Ideal voltage source is one whose internal resistance is zero
Ideal voltage source is one whose internal conductance is zero
Ideal voltage source is one whose generated voltage is equal to the available terminal voltage
Ideal current source is one whose internal conductance is zero

⇒ An integrating amplifier has resistance in feedback path.
TRUE
FALSE

⇒ In a C expression using assignment operators, relational operators and arithmetic operators, the hierarchy of operations (in the absence of parenthesis) is
assignment, relational, arithmetic
relational, assignment, arithmetic
arithmetic, assignment, relational
arithmetic, relational, assignment

⇒ Mark the false statement:
since wave-shape of a digital signal is unimportant, linear amplifiers are not required
the precise amplitude of a digital signal is also unimportant provided two voltage levels (0 and 1) are quite different
the leading and trailing edges of a digital signal need not be sharp
actual digital waves have rise and fall times of the order of a few nano seconds

⇒ In the circuit of the given figure, V_{05 V
3.1 V
2.5 V
0}

⇒ The circuit of figure is used to measure the value R_x. Ammeter resistance R_a = 0.1 Ω voltmeter resistance R_v = 5000 Ω. It R_x1 and R_x2, are the measured values of R_x with switch in position 1 and 2, the mean of R_x1, and R_x2,
9.98 Ω
10 Ω
10.04 Ω
10.1 Ω

⇒ MUF is depend upon
electron density of the ionospheric layer
11 year sun spot cycle
received frequency by receiver
height of ionospheric layer

⇒ The pre-emphasis circuit is used
prior to modulation
after demodulation
for low frequency components of the signal
none of the above

⇒ In a bipolar transistor the barrier potential
0
a total of 0.7 V
0.7 V across each depletion layer
0.35 V

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ With I_s disconnected I = - 1, when I_s = b is connected, the value of I will be
0.0833333333333333
-1 A
0.0416666666666667
0.125

⇒ Household tape recorders use
separate motor for each operation
only one motor for all operations
one motor for capstan and another for take up reel
a total of 3 motors