Question is ⇒ In the figure circuit, V1 = 40 V. When R is 10 Ω. When R is zero, the value of V2 wil, Options are ⇒ (A) 40 V, (B) 30 V, (C) 20 V, (D) 10 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In the figure circuit, V1 = 40 V. When R is 10 Ω. When R is zero, the value of V2 wil, Options are ⇒ (A) 40 V, (B) 30 V, (C) 20 V, (D) 10 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the figure circuit, V₁ = 40 V. When R is 10 Ω. When R is zero, the value of V₂ wil
A.	40 V [Correct Answer]
B.	30 V [Wrong Answer]
C.	20 V [Wrong Answer]
D.	10 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Boolean function/implemented in the figure using two I/P multiplexer
ABC + ABC
ABC + AB C
ABC + ABC
ABC + AB C

⇒ In the given figure the circuits for input impedance of a microwave device with output ports match terminated. The devic
E plane tee
H plane tee
magic tee
hybrid ring

⇒ The most widely used diode rectifier circuit is
half wave
full wave with centre tapped transformer
bridge
either (a) or (b)

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ The following circuit resonate
0.5 Hz
5 Hz
1 rad/sec
0.5 rad/sec

⇒ A logical expression Y = A + AB is equal to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ For an RC impedance function
all poles lie on jω axis
all poles are simple ,
all poles are simple and lie on negative real axis
none of the above

⇒ If a system is to follow arbitrary inputs accurately the bandwidth should be
large
small
very small
neither small nor large

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒ Troposphere is the portion of atmosphere
nearest to ground
between 50 to 90 km above ground
between 110 to 220 km above ground
between 250 to 350 km above ground

⇒ Decimal 45.15 when converted into 9's complement will become
54.84
45.48
48.54
45.84

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒ In using Nyquist stability criterion it is not necessary to determine closed loop poles.
TRUE
FALSE

⇒ The semiconductor diode which can be used in switching circuit in microwave range is
PIN diode
Varactor diode
Tunnel diode
Gunn diode

⇒ For a P-N diode, the number of minority carriers crossing the junction depends on
forward bias voltage
potential barrier
rate of thermal generation of electron hole pairs
none of the above

⇒ In 8085 stack pointer is
4 bit register
8 bit register
16 bit register
32 bit register

⇒

Assertion (A): A JFET behaves as a resistor when V_GS < V_P.

Reason (R): When V_GS < V_P, the drain current in a JFET is almost constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): CRO can be used to study waveshape accurately.

Reason (R): Input impedance of a CRO is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ When a superheterodyne receiver is tuned to 455 kHz, its local oscillator provides a mixer with the input at 1010 kHz. The image frequency is
555 kHz
1010 kHz
1465 kHz
1920 kHz

⇒ In a microprocessor
one machine cycle is equal to one clock cycle
one clock cycle consists of several machine cycles
one machine cycle consists of several clock cycles
one machine cycle is always less than one clock cycle

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ Solution of Laplace equations, which are continuous through the second derivative, are called
bessel functions
odd functions
harmonic functions
fundamental functions

⇒ The light output of LED varies as (current)ⁿ. The value of n is about
0.5
1
1.3
2.1

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ For a second order system ω_n is natural frequency, ω_d is frequency of damped oscillations and ζ is damping factor. Then
ω_d = ω_n ξ
ω_d = ω_n (1 - ξ)²
ω_d = ω_n (1 - ξ)^0.5
ω_d = ω_n (1 - ξ²)^0.5

⇒ If resistance is 20 Ω and inductance is 2 H in a R-L series circuit, then time constant of this will be
0.001 s
0.1 s
10 s
100 s

⇒ In figure, the battery has remained switched on for a long time. At t = 0 the switch is closed. The current i(t) is likely t
6
6 - 3e^-1
6 + 3e^-1
3 - 6e^-1