Question is ⇒ In the design of a distributor which of the following is the major consideration ?, Options are ⇒ (A) Voltage drop, (B) Current carrying capacity, (C) Frequency, (D) kVA of system, (E) None of the above, Leave your comments or Download question paper.

Question is ⇒ In the design of a distributor which of the following is the major consideration ?, Options are ⇒ (A) Voltage drop, (B) Current carrying capacity, (C) Frequency, (D) kVA of system, (E) None of the above, Leave your comments or Download question paper. Previous question Next question


Q1.	In the design of a distributor which of the following is the major consideration ?
A.	Voltage drop [Correct Answer]
B.	Current carrying capacity [Wrong Answer]
C.	Frequency [Wrong Answer]
D.	kVA of system [Wrong Answer]
E.	None of the above [Wrong Answer]
View Answer 15 -12 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ By using bundle conductors, the critical voltage for the formation of corona will
remain same
decrease
increase
not occur

⇒ In which of the following cases shunt capacitance is negligible ?
Short transmission lines
Medium transmission lines
Long transmission lines
All transmission lines

⇒ The effect of corona can be detected by
presence of zone detected by odour
hissing sound
faint luminous glow of bluish colour
all of the above

⇒ In context of corona, if the conductors are polished and smooth, which of the following statements is correct ?
Hissing sound will be more intense
Power loss will be least
Corona glow will be uniform along the length of the conductor
Corona glow will not occur

⇒ Owing to skin effect
current flows through the half cross-section of the conductor
portion of the conductor near the surface carries more current and core of the conductor carries less current
portion of the conductor near the surface carries less current and core of the conductor carries more current
any of the above

⇒ Which of the following is the source of heat generation in the cables ?
Dielectric losses in cable insulation
IR losses in the conductor
Losses in the metallic sheathings and armourings
All of the above

⇒ Skin effect exists only in
a.c. transmission
high voltage d.c. overhead transmission
low voltage d.c. overhead transmission
cables carrying d.c. current

⇒ The power factor of industrial loads is generally
unity
lagging
leading
zero

⇒ Transmission lines link
generating station to receiving end station
receiving end station to distribution transformer
distribution transformer to consumer premises
service points to consumer premises

⇒ Which of the following equipment, for regulating the voltage in distribution feeder, will be most economical ?
Static condenser
Synchronous condenser
Tap changing transforraer
Booster transformer

⇒ Multicore cables generally use
square conductors
circular conductors
rectangular conductors
sector-shaped conductors

⇒ Overhead system can be designed for operation upto
11 kV
33 kV
66 kV
400 kV

⇒ The operating voltage of supertension cables is upto
3.3 kV
6.6 kV
11 kV
33 kV

⇒ System grounding is done so that
inductive interference between power and communication circuits can be controlled
the floating potential on the lower voltage winding for a transformer is brought down to an insignificant value
the arcing faults to earth would not set up dangerously high voltage on healthy phases
for all above reasons

⇒ Which of the following regulations is considered best ?
0.5
0.2
0.1
0.02

⇒ Impedance relay is used on ____ transmission lines
short
medium
long
all

⇒ A gay wire
protects conductors against shortcircuiting
provides emergency earth route
provides protection against surges
supports the pole

⇒ Power loss due to corona is not directly proportional to
spacing between conductors
supply voltage frequency
phase-neutral voltage
all of the above

⇒ The surge resistance of cables is
20 ohms
50 ohms
200 ohms
300 ohms

⇒ High voltage is primarily used, for long distance power transmission, to
reduce the time of transmission
reduce the transmission losses
make the system reliable
none of the above

⇒ The colour of the neutral of three-core flexible cable is
blue
brown
red
black

⇒ Transmitted power remaining the same, if supply voltage of a D.C. 2-wire feeder is increased 100 percent, saving in copper is
25 percent
50 percent
75 percent
100 percent

⇒ Which of the following short-circuits is most dangerous ?
Dead short-circuit
Line to ground short-circuit
Line to line short-circuit
Line to line and ground short-circuit

⇒ The conductors are bundled primarily to
increase reactance
reduce reactance
reduce radio interference
none of the above

⇒ Pin type insulators are generally not used for voltages beyond
1 kV
11 kV
22 kV
33 kV

⇒ Due to which of the following reasons the cables should not, be operated too hot ?
The oil may loose its viscosity and it may start drawing off from higher levels
Expansion of the oil may cause the sheath to burst
Unequal expansion may create voids in the insulation which will lead to ionization
The thermal instability may rise due to the rapid increase of dielectric losses with temperature

⇒ The cause of damage to the lead sheath of a cable is
crystallisation of the lead through vibration
chemical action on the lead when buried in the earth
mechanical damage
all of the above

⇒ The minimum clearance between the ground and a 220 kV line is about
4.3 m
5.5 m
7.0 m
10.5 m

⇒ In a D.C. 3-wire distributor using balancers and having unequal loads on the two sides
both balancers run as generators
both balancers run as motors
balancer connected to lightly- loaded side runs as a motor
balancer connected to heavily- loaded side runs as a motor