Question is ⇒ In the CMOS inverter, Options are ⇒ (A) one transistor is N channel and the other P channel, (B) one is enhancement type and other depletion type, (C) both are N channel with one enhancement and the other depletion type, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ In the CMOS inverter, Options are ⇒ (A) one transistor is N channel and the other P channel, (B) one is enhancement type and other depletion type, (C) both are N channel with one enhancement and the other depletion type, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the CMOS inverter
A.	one transistor is N channel and the other P channel [Wrong Answer]
B.	one is enhancement type and other depletion type [Correct Answer]
C.	both are N channel with one enhancement and the other depletion type [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹⁰/ cm³ the electron concentration is
zero
10¹⁰/cm³
10⁵/cm³
1.5 x 10²⁵/cm³

⇒ If 4 quadrant operation is required we need
dual converter
full converter
semi converter
none of the above

⇒ A transistor has

collector
emitter
base

In a N-P-N transistor the electron flow into the transistor at
I only
II only
II and III only
I and II only

⇒ In Laplace transform, multiplication by e^-at in time domain becomes
translation by a in s domain
translation by (-a) in s domain
multiplication by e^-as in s domain
none of the above

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ A pole zero plot of a filter is shown in figure. I
low pass filter
high pass filter
band pass filter
all pass filter

⇒ In FM, the frequency deviation is
always constant
directly proportional to modulating frequency
inversely proportional to modulating frequency
proportional to amplitude of modulating signal

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒ In standard TTL the totem pole stage refers to
multiemitter input stage
phase splitter
output buffer
open collector output stage

⇒ In a wave the electric field lines are vertical. Then the wave is
horizontally polarized
vertically polarized
either (a) or (b)
neither (a) nor (b)

⇒ A 3 stage Johnson counter shown in figure is clocked at a constant frequency of f_c from the starting state of Q₀ Q₁ Q₂ = 101. The frequency of output Q₀ Q₁ Q₂ wil
f_c/2
f_c/3
f_c/6
f_c/8

⇒ The inverse Laplace transform of 1/(s - a)² is
e^at
t e^at
t² e^at
e^at/t

⇒ In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
power supply
loudspeaker
AGC, video IF amplifier, RF amplifier
horizontal oscillator

⇒ A parallel RLC network has R = 4Ω, L = 4H, C = 0.25F. Then at resonance Q =
1
10
20
40

⇒ When the length of antenna is a whole wavelength
the radiation at right angles is zero
the radiation at right angles is maximum
the radiation is zero in all directions
the radiation is maximum in all directions

⇒ Which family of logic circuits uses field effect transistors?
TTL
CMOS
Both LED and well as LCD
None of the above

⇒ Consider the following statement : If a network has an impedance of (1 - j) as a specific frequency, the circuit would consist of series

R and C
R and L
R, L and C

Which of the statement are correct?
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ Status register in the 8156 is read with
IN 20 H
OUT 20 H
either (a) or (b)
none of the above

⇒ The drain characteristics of JFET in operating region, are
inclined upwards
almost flat
inclined downwards
inclined upwards or downwards

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ The wavelength of an electromagnetic wave after reflection at angle on a surface
remains same as the wavelength perpendicular to the surface
remains same in the free space
increases in actual direction of propagation
decreases in actual direction of propagation

⇒ DeMorgan's second theorem is
A . A = 0
A = A
A + B = A . B
AB = A + B

⇒ The number of digit 1 present in the binary representation of 3 x 512 + 7 x 64 + 5 x 8 + 3 is
8
9
10
12

⇒ In figure, R = 20KΩ and C = 75 pF. The converter clock frequency wil
606 Hz
1212 Hz
555 KHz
606 KHz

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ The flow rate of electrically conducting liquid without any suspended particle can not be measured by
turbine flow meter
electromagnetic flow meter
ultrasonic flow meter
thermistor based heat flow meter

⇒ A sample of N-type semiconductor has electron density of 6.25 x 10¹⁸/cm³ at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ The counter shown in the given figure is built using 4 -ve edge triggered toggle FFs. The FF can be set asynchronously when R = 0. The combinational logic required to realize a modulo-13 counte
F = Q₄ Q₃ Q₂ Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄Q₃Q₂Q₁

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above