Question is ⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0+ is give, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 42828, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0+ is give, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 42828, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
A.	1 [Correct Answer]
B.	2 [Wrong Answer]
C.	3 [Wrong Answer]
D.	42828 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ IC 7485 cannot be cascaded.
TRUE
FALSE

⇒ Which of the following is incorrect?
11101 + 10 = 11111
(8)₈ + (2)₈ = (11)₈
(8)₁₆ + (7)₁₆ = E
All of them are incorrect

⇒ For a npn BJT transistor f_β is 1.64 x 10⁸ Hz. C_μ = 10^-14 F; C_p = 4 x 10^-13 F and DC current gain is 90. Find f_T and g_m (f_β = cut off frequency, C_μ = capacitance, C_p = parasitic capacitance, g_m = transconductance, f_T = gain BW product)
f_T = 1.47 x 10¹⁰ Hz ; g_m = 38 milli mho
f_T = 1.64 x 10⁸ Hz ; g_m = 30 milli mho
f_T = 1.47 x 10⁹ Hz ; g_m = 38 mho
f_T = 1.33 x 10¹² Hz; g_m = 0.37 m-mho

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ RF amplifiers are used in radio receivers for
better sensitivity
improved signal-to-noise ratio
better coupling of receiver to the antenna
all of the above

⇒ In the circuit shown in the given figure the diode states at the extremely large negative values of the input voltage v_i a
D₁ off, D₂ off
D₁ on, D₂ off
D₁ off, D₂ on
D₁ on, D₁ on, D₂ on

⇒ Consider the following statements regarding the properties of an R-L-C series circuit under resonance:

Current in the circuit is in phase with applied voltage
Voltage drop across capacitor C and inductance L are equal in magnitude.
Voltage across the capacitor is equal in magnitude to the applied voltage.
Current in the circuit is maximum.

Which of the above statements is/are correct?
1 only
1, 2 and 4
2 and 4
1, 3 and 4

⇒

Match the following:

	List I (Antenna)		List II (Communication system)
A.	Turnstile	1.	Radar
B.	Yagi	2.	TV transmission
C.	Dish	3.	MW broadcasting
D.	Vertical mast	4.	TV reception

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-2, B-4, C-3, D-1
A-4, B-2, C-1, D-3

⇒ As the area of a public meeting increases the amplifier power output required increases.
TRUE
FALSE

⇒ In the given fi
42737
42739
2
1

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code

⇒ Power received from Sun per m² surface area of a geosynchronous satellite in nearly __________ watt.
100
500
2000
1000

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ When phase-lag compensation is used in a system, then gain cross over frequency, bandwidth and undamped frequency are respectively
Increased, Increased, Increased
Increased, Increased, Decreased
Increased, Decreased, Decreased
Decreased, Decreased, Decreased

⇒ The minimum number of equations required to analyze the circuit shown in the figur
3
4
6
7

⇒ Windows automatically starts CD player when one inserts audio CD in CD-ROM drive.
TRUE
FALSE

⇒ A cordless telephone using separate frequencies for transmission in base and portable units is known as
duplex arrangement
half duplex arrangement
either (a) or (b)
neither (a) nor (b)

⇒ In LED the radiation is in
visible region
infrared region
both (a) and (b)
neither (a) nor (b)

⇒ On which bands, do the optical fibers operate?

Ultra violet band
Ultra high frequency band
Visible light band
Infrared band

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ Which stage generates RF carri
Amplifier
Oscillator
Power supply
All of the above

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
1.9 k bits/sec
0.95 k bits/sec
3.8 k bits/sec
7.6 k bits/sec

⇒ In a 4 bit counter the output of 3 JK FFs from MSB downward are connected to the NAND gate whose O/P is connected to CLR
it is a MOD-14 counter
it is MOD-13 counter
it is divided by 13 counter
it is divide by 10 counter

⇒ Neutralization is used in RF amplifiers to
stop oscillation
increase bandwidth
improve selectivity
all of the above

⇒ A surge voltage
has very high magnitude and very long duration
has very high magnitude and very small duration
has very high magnitude and very small duration and can be positive or negative
can be only positive

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ Which of the following statements is/are true for the diamond structure?

Coordination number is four.
Packing fraction is 0.34
Copper crystallizes into diamond structure
Lattice is FCC.

1 only
1, 2 and 4
2 and 3 only
2, 3 and 4

⇒

Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above