Question is ⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of, Options are ⇒ (A) 30 Ω, (B) 10 Ω, (C) 9 Ω, (D) zero, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of, Options are ⇒ (A) 30 Ω, (B) 10 Ω, (C) 9 Ω, (D) zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of
A.	30 Ω [Wrong Answer]
B.	10 Ω [Wrong Answer]
C.	9 Ω [Wrong Answer]
D.	zero [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A parallel resonant circuit can be used
as a high impedance
to reject a small band of frequencies
both (a) and (b)
to amplify certain frequencies

⇒ In an ac single phase energy meter, the potential coil is put on
both side limbs, of upper magnet
central limb of upper magnet
one side limb of upper magnet
either (a) or (b)

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒ Which group of instructions is used to change sequence of operations in a computer program?
Data transfer group
Branch group
Arithmetic group
Logic group

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ The transconductance curve of a JFET is
a straight line
parabolic
hyperbolic
inverted V-type

⇒ In a microprocessor
all instructions need only one machine cycle
some instructions need only one machine cycle while some other instructions need more than one machine cycle
all instructions need only fraction of one machine cycle
some instructions need less than one machine cycle

⇒ Which of the following is used to obtain output position in a position control system?
Strain gauge
Load cell
Synchro
Thermistor

⇒ The mean life time of the minority carriers is in the range of a few
seconds
milli seconds
micro seconds
nano seconds

⇒ A . 0 =
1
A
0
A or 1

⇒ The statement ! (b < 5) in C means
b = 5
b > 5
b > = 5
none of the above

⇒

Match the following:

	List I		List II
A.	Former	1.	Produces deflecting torque
B.	Coil	2.	Provides base for coil
C.	Core	3.	Makes the magnetic field radial
D.	Spring	4.	Provides controlling torque

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3

⇒ The properties of JFET resemble those of
thermionic values
N-P-N transistors
P-N-P transistors
unijunction transistor

⇒ A piece of copper and another piece of Germanium are cooled from 30°C to 80 K. The resistance of
copper decreases and germanium increases
both decreases
both increases
copper increases and germanium decreases

⇒ Substitution theorem applies to
Linear network
Non linear network
Linear time invariant network
Any network

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ The phase difference (jω - p₁) means
phasor drawn from p₁ to jω
phasor drawn from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒ In operational Amplifier, Common mode voltage gain should be
0
∞
1
0.5

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ Consider the following stateme
1 only
1 and 2
2 and 3
2 and 4

⇒ An LED is
an ohmic device
a display device
a voltage regulated device
all of the above

⇒ How can the bandwidth of a control system be increased?
By the use of phase lead network
By the use of phase lag network
By the use of both phase-lag and phase-lead network
By the use of cascaded amplifiers in the system

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ The simplest register is
buffer register
shift register
controlled buffer register
bidirectional register

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ The Z parameters Z₁₁ and Z₂₁ for the 2-port network in the fig
Z₁₁ = - 6/₁₁Ω; Z₂₁ = 16/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = 4/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = - 16/₁₁Ω
Z₁₁ = 4/₁₁Ω; Z₂₁ = 4/₁₁Ω

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ An energy signal has G(f) = 10. Its energy density spectrum is
10
100
50
20

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV