Question is ⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at <i>t</i> = 0. The initial value of the current through the capacitor 2, Options are ⇒ (A) zero, (B) 0.0416666666666667, (C) 0.0833333333333333, (D) 0.125, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at <i>t</i> = 0. The initial value of the current through the capacitor 2, Options are ⇒ (A) zero, (B) 0.0416666666666667, (C) 0.0833333333333333, (D) 0.125, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
A.	zero [Wrong Answer]
B.	0.0416666666666667 [Wrong Answer]
C.	0.0833333333333333 [Correct Answer]
D.	0.125 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Read the following statements about address space in microprocessors

An address space is a set of all possible addresses which can be generated by a microprocessor.
Each address in the address space allows a designer to provide at least one memory or I/O location in the system.
Two types of address spaces are memory and I/O address space.
Some micro processors have only one type of address space.

Which of the above are correct?
All
1, 2, 3 only
1, 2, 4 only
1, 3, 4 only

⇒ Consider the following logical IF statement in FORTRAN 77 IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 13, 11, 13
IF (SALT - PEPPER) 13, 11, 11
IF (SALT - PEPPER) 11, 13, 13

⇒ An inductor filter has a ripple that __________ with load resistance and consequently is used only with relatively __________ load currents.
decreases, low
decreases, high
increases, low
increases, high

⇒ In a second order system ω_n = 10 rad/sec and ζ = 0.1, then ω_d =
9.1 rad/sec
9.95 rad/sec
9 rad/sec
1 rad/sec

⇒ In order to receive a vertical polarized wave, the conductor of the dipole should be mounted
horizontally
vertically
at an angle of 45°
at an angle of 90°

⇒ In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then
C = log₂ N
C = (δf) log₂ N
C = 2 (δf) log₂ N
C = 0.5 (δf) log₂ N

⇒

Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following statements

In 8085 address and data buses are multiplexed.
In Z 80 address and data buses are multiplexed
In Z 80 address and data buses are not multiplexed.
Z 80 has 16 bit address bus and 8 bit data bus.

Which of the above statements are correct?
1 and 2 only
1, 3 and 4 only
1, 2 and 4 only
2 and 4 only

⇒ When diodes are connected in series to increase voltage rating the peak inverse voltage per junction
should not exceed half the breakdown voltage
should not exceed the breakdown voltage
should not exceed one third the breakdown voltage
may be equal to or less than breakdown voltage

⇒ A rectifier voltmeter using bridge rectifier and PMMC meter is calibrated to read rms value of sine wave. A triangular wave is applied to it and it reads 6.82 V. The rms value of triangular wave is
about 6.82 V
about 7.1 V
about 6.5 V
about 10 V

⇒ The process of entering data into ROM is called
writing
burning
decoding
registering

⇒ A planar graph has 6 nodes and 7 branches. The number of meshes in the dual graph is
2
3
4
6

⇒ In case of a transistor amplifier the emitter resistance R_e is removed
the gain of the amplifier will reduce
heat sink will not be required
Q-point will become unstable
base to emitter function will be less forward biased

⇒ The relation between the apparent power, actual power and reactive power is given by
Apparent power = actual power + reactive power
Apparent power = actual power - reactive power
Apparent power = (actual power)² - (reactive power)²
Apparent power = (actual power)² + (reactive power)²

⇒ The polynomial P (s) = (s - 1) (s² + 1) (s + 2) (s + 3) is
Hurwitz but not strictly Hurwitz
not Hurwitz
strictly Hurwitz
anti/Hurwitz

⇒ A silicon PN junction with no bias have a doping concentration
3.345 x 10^-3 cm
3.345 x 10^-4 cm
3.345 x 10^-5 cm
3.345 x 10^-6 cm

⇒ Which are the pending interrupts?
5.5
6.5
7.5
None

⇒ UJT can be used for
firing an SCR
turning off an SCR
both firing and turning off an SCR
none of the above

⇒ If the memory chip size is 256 x 1 bits, then the number of chips required to make up 1 kB (1024) bytes of memory is
32
24
12
8

⇒ For a given voltage, four heating coils will produce maximum heat when connected
all in parallel
all in series
with two parallel pairs in series
one pair in parallel with the other two in series

⇒ A half adder adds __________ bits and a full adder adds __________ bits.
two, three
three, four
four, six
two, four

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will accumulator (A) and carry (CY) contain after ANA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ VSWR can have any value between
0 and 1
- 1 to + 1
0 to ∞
1 to ∞

⇒ The first contribution to logic was made by
George Boole
Copernicus
Aristotle
Shannon

⇒ A typical signal strength received from a geosynchronous communication satellite is of the order of a few
milliwatts
kilowatts
picowatts
watts

⇒

Match the following:

	List I (Library function in Pascal)		List II (Type of argument)
A.	ROUND X	1.	X in radians
B.	ABS X	2.	X real
C.	SQR X	3.	X real or integer
D.	SIN X

A-2, B-3, C-3, D-1
A-2, B-3, C-1, D-3
A-3, B-2, C-2, D-1
A-2, B-3, C-2, D-1

⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
0 V
10 V
20 V
40 V

⇒ In electromagnetic wave polarization is caused by
refraction
reflection
longitudinal nature of electromagnetic waves
transverse nature of electromagnetic waves

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......