Question is ⇒ In the circuit shown in figure, Is = 4A, Vs = 4, the voltage V is give, Options are ⇒ (A) 6 V, (B) 8 V, (C) 4 V, (D) 2 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit shown in figure, Is = 4A, Vs = 4, the voltage V is give, Options are ⇒ (A) 6 V, (B) 8 V, (C) 4 V, (D) 2 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit shown in figure, I_s = 4A, V_s = 4, the voltage V is give
A.	6 V [Correct Answer]
B.	8 V [Wrong Answer]
C.	4 V [Wrong Answer]
D.	2 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the following is not a negative resistance device?
Gunn diode
Tunnel diode
Impatt diode
Varactor diode

⇒ In figure the zener cur
is always 130 mA
may vary between 10 mA and 130 mA
may vary between 60 mA and 130 mA
is always equal to 65 mA

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
6 dB and 180°
3 dB and 180°
6 dB and 90°
3 dB and 90°

⇒ The superposition theorem is applicable to
linear, non-linear and time variant responses
linear and non-linear resistors only
linear responses only
none of the above

⇒ In a valence crystal, the valence electrons
are not shared
are shared between neighbouring atoms
are shared by all atoms
any of the above

⇒ V-I relationship of a network N is given by, V = 8 -
0, 2
0, 4
2, 4
None of these

⇒ Noise temperature of Sun is more than __________ °K.
1000
5000
100000
500

⇒ Choose the function f(t), - ∞ < t < + ∞, for which a Fourier series cannot be defined
3 sin (25t)
4 cos (20t + 3) + 2 sin (10t)
exp - | t | sin 25 t
1

⇒ The term critical frequency denotes
the lowest frequency that is reflected by the ionosphere
the highest frequency that is reflected by the ionosphere at vertical distance
the lowest frequency by which communication is possible between two given points
none of the above

⇒ The sum of two sine waves of different frequencies is a sine wave.
TRUE
FALSE

⇒ BCD numbers are useful whenever
binary to hexadecimal conversion is desired
binary to BCD conversion is desired
decimal information is transferred into or out of a digital system
none of the above

⇒ Which of these commutation methods is used in AC-DC converters?
Class A
Class C
Class D
Class F

⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron
will be increased
will be decreased
will remain the same
either (a) or (b)

⇒ In PAL system
phase of U signal is reversed on alternating lines
phase of V signal is reversed on alternating lines
phases of both U and V signals are reversed on alternating lines
none of the above

⇒ At absolute zero temperature a semiconductor behaves like
an insulator
a super conductor
a good conductor
a variable resistor

⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz

⇒ Which of the following is true?
Intel 8080 was the ancestor of Intel 8085
Intel 8080 was the ancestor of Intel Z 80
Intel 8080 was the ancestor of both Intel 8085 and Z 80
Intel 8085 was the ancestor of Intel 8085

⇒ A P-channel MOSFET operating in the enhancement mode is characterized by V_t = - 4 V and I_DQ = - 10 mA, when V_GSQ = - 5.5 V, what will be V_GSQ if I_DQ = -15 mA and I_{D, on} = - 16 mA
- 2 V
3 V
0.13 V
1.3 V

⇒ If the current in a capacitor leads the voltage by 80°, the loss angle of capacitor is
80°
10°
100°
170°

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒

Assertion (A): In a BCD to 7 segment decoder the number of outputs active at one time is always the same.

Reason (R): A decoder can be used to interface BCD input to LED display.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In figure, the charge on 0.8 μF capacito
100 μC
50 μC
40 μC
20 μC

⇒ For a level input sequential circuit
output in a level only
output is in the pulse form
output may be a pulse or a level form
none of these

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. When the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒

Assertion (A): The gate current of an SCR is always in the form of pulses.

Reason (R): The gate losses, in pulse triggering, are low.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following array names in Fortran 77 is invalid?
A(6)
A(R)
A(I)
A(N)

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2

⇒ The number FF in hexadecimal system is equivalent to number __________ in decimal system.
256
255
240
239

⇒ When there is rapid attenuation of field inside the conductor, the field current are concentrated close to the surface of the conductor; this phenomenon is called
skin effect
EM concentration effect
Faraday's effect
Ohm's effect