Question is ⇒ In the circuit shown below, the outputs Y1 and Y2 for the given initial condition Y1 = Y2 = 1 and after four input pulses wil, Options are ⇒ (A) Y1 = 1, Y2 = 0, (B) Y1 = 0, Y2 = 0, (C) Y1 = 0, Y2 = 1, (D) Y1 = 1, Y2 = 1, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit shown below, the outputs Y1 and Y2 for the given initial condition Y1 = Y2 = 1 and after four input pulses wil, Options are ⇒ (A) Y1 = 1, Y2 = 0, (B) Y1 = 0, Y2 = 0, (C) Y1 = 0, Y2 = 1, (D) Y1 = 1, Y2 = 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
A.	Y₁ = 1, Y₂ = 0 [Wrong Answer]
B.	Y₁ = 0, Y₂ = 0 [Wrong Answer]
C.	Y₁ = 0, Y₂ = 1 [Wrong Answer]
D.	Y₁ = 1, Y₂ = 1 [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above

⇒ In a digital voltmeter the oscillator frequency is 400 kHz and the ramp voltage falls from 8 V to 0 V in 20 ms. What is the number of pulses counted by the counter?
800
2000
4000
8000

⇒ In 8085 microprocessor, what is the length of status Word?
6 bits
8 bits
12 bits
16 bits

⇒ Zero suppression is not used in actual practice.
TRUE
FALSE

⇒ A circuit has two branches in parallel and each branch has only one element. The applied voltage and source current are v = 200 sin (200t + 30°) and i = 50 sin (200t + 50°). If one branch has capacitor, the other branch contains
resistance
inductance
capacitance
resistance or capacitance

⇒ In a reverse biased p-n junction, the reverse bias is 4V. The junction capacitance is about
0.1 F
4 μF
10 nF
20 pF

⇒ The kinetic energy of photoelectrons emitted by a photo sensitive surface depends on
intensity of the incident radiation
wavelength of the incident radiation
surface conditions of the surface
angle of incidence of radiation

⇒ Consider the following applications

TV tuning
Active filter
Microwave frequency multiplication

In which of above can a varactor diode be used?
1 2 and 3
l and 2 only
1 and 3 only
2 and 3 only

⇒

Assertion (A): The capacitance of a reverse biased pin diode is lower than that of reverse biased p-n diode.

Reason (R): A PIN diode has an intrinsic layer between p and n regions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The output Y of the circuit shown in the figur
(A + B) C + DE
AB + C(D + E)
(A + B) C + D + E
(AB + C) . DE

⇒

Assertion (A): The response of a network to unit impulse can be obtained directly from the network function.

Reason (R): The response of a network for any input can be obtained from impulse response.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ An ammeter has a resistance of 50 ohms and a shunt of 0.01 Ω. The deflection is θ. If the shunt resistance is increased to 0.02 Ω, the deflection will be.
θ
2θ
0.5θ
0.25θ

⇒ In a T flip-flop the output frequency is
same as input frequency
half of I/p frequency
double the input frequency
none

⇒ In a 3 phase bridge inverter with 180° mode of operation the numbers of thyristors conducting at one time are
1
2
3
4

⇒ A TRIAC can be turned on :
by applying a positive signal to gate
by applying a negative signal to gate
by applying either positive or negative signal to gate
none of the above

⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2

⇒ When a capacitor is connected to the terminals of an ohmmeter, the pointer indicated a low resistance initially and finally come to infinity position. This shows that capacitor is
short circuited
all right
faulty
open circuited

⇒ The self bias provides
stable Q point
large voltage gain
high input impedance
high base current

⇒ A system is said to be marginal stable if
poles lies on Real axis
zero lies on Real axis
poles lies on Imaginary axis
zeros lies on origin

⇒ Which of these commutation methods uses two leads?
Class A
Class B
Class C
Class D

⇒ For pole-zero plot shown, the system is ________
minimum phase
maximum phase
mixed phase
none of these

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ The total number of input words for 4 input OR gate is
20
16
12
8

⇒ If σ standard deviation, probable error
σ
± 1.19 σ
± 0.6745 σ
± 0.4125 σ

⇒ The poles and zeros of a positive real function
may lie any where in s plane
may have positive or negative real part
must occur in conjugate pair
must have either negative or zero real part

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Determine the voltage V_CB in the circuit bel
3.4 V
5.4 V
7.4 V
9.4 V

⇒ A dielectric does not have leakage current.
TRUE
FALSE