Question is ⇒ In the case of the circuit shown in the figure, the collector current IC will be, if β = 100, VBE = 0.7 V, ICO = 0.1 βA at 20&d, Options are ⇒ (A) 2.26 mA, (B) 1.85 mA, (C) 0.357 mA, (D) 0.185 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ In the case of the circuit shown in the figure, the collector current IC will be, if β = 100, VBE = 0.7 V, ICO = 0.1 βA at 20&d, Options are ⇒ (A) 2.26 mA, (B) 1.85 mA, (C) 0.357 mA, (D) 0.185 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the case of the circuit shown in the figure, the collector current I_C will be, if β = 100, V_BE = 0.7 V, I_CO = 0.1 βA at 20&d
A.	2.26 mA [Correct Answer]
B.	1.85 mA [Wrong Answer]
C.	0.357 mA [Wrong Answer]
D.	0.185 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ ROC of sequence x[n] = δ[n] is
Not exist
z = 0
Entire Plane
Entire Plane expect z = 0, z = ∞

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ The FM broadcast band is from
550 to 1600 kHz
88 to 108 kHz
88 to 108 MHz
1600 kHz to 59.75 MHz

⇒ The law J = σE, where J is current density, σ is electrical conductivity and E is field strength is
Ohm's law
Gauss law
Ampere's law
Biot-Savart law

⇒ An SR flip flop can be built using
NOR gate only
NAND gate only
either NOR or NAND gates
neither NOR nor NAND gates

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): A good op-amp should have very large band width

Reason (R): An ideal op-amp should have infinite input resistance and zero output resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
sin^-1 ξ
cos^-1 ξ
tan^-1 ξ
cot^-1 ξ

⇒ When the circuit is switched on, the loop gain of a Wien bridge oscillator is
1
more than 1
less than 1
about 0.5

⇒ Figure represen
Esaki diode
Triac
Varactor
Gunn diode

⇒ In order to achieve accuracy, the slide wire of a potentiometer should be
as long as possible
as short as possible
neither too long nor too short
very thin

⇒ Addition of a small amount of antimony to germanium will result in
formation of p-type semiconductor
more free electrons than holes in semiconductor
antimony concentrating on the edges of the crystal
increased resistance

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ Status register in the 8156 contains information about
the timer
the ports
both (a) and (b)
none of the above

⇒ For making a capacitor it is better to have a dielectric having
high permittivity
low permittivity
permittivity same as that of air
permittivity which is neither high nor low

⇒ A reverse voltage of 18 V is applied to a semiconductor diode. The voltage across the depletion layer is
0 V
0.7 V
about 10 V
18 V

⇒ Consider the following statements associated with two port networks.

Z₁₂ = Z₂₁
Y₁₂ = Y₂₁
h₁₂ = h₂₁
AD - BC = 1

Which one of the statement given above are correct?
1, 2, 3
2, 3, 4
1, 3, 4
1, 2, 4

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ The dimension of flux density is
MT^-1Q^-1
MT^-2
MT¹Q¹
MT^-1Q^-2

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ The number of logic or arithmetic operations with ALU 1C 74181 can carry out is
4
8
16
32

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ Antenna radiation efficiency can be increased by
reducing radiation resistance of the system
increasing radiation resistance of the system
providing effective earthing
any of the above

⇒ Use of high permeability core in moving iron instrument helps in
reducing size of meter
increasing sensitivity
reducing temperature error
all of the above

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse