Question is ⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R<sub>E</sub>, Options are ⇒ (A) decrease the voltage gain and decrease the I/P impedance, (B) increase the voltage gain and decrease the I/P Impedance, (C) decrease the voltage gain and Increase the I/P impedance, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R<sub>E</sub>, Options are ⇒ (A) decrease the voltage gain and decrease the I/P impedance, (B) increase the voltage gain and decrease the I/P Impedance, (C) decrease the voltage gain and Increase the I/P impedance, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
A.	decrease the voltage gain and decrease the I/P impedance [Wrong Answer]
B.	increase the voltage gain and decrease the I/P Impedance [Correct Answer]
C.	decrease the voltage gain and Increase the I/P impedance [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ The constant M loci on G(s) plane are a family of circles.
TRUE
FALSE

⇒ In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
100 v
0 v
∞
- 100 v

⇒ The number of inputs and outputs of a full adder are
3 and 2 respectively
2 and 3 respectively
4 and 2 respectively
2 and 4 respectively

⇒ The velocity of sound waves in air
is constant at all temperatures
varies directly as temperature
varies inversely as absolute temperature
varies directly as square root of absolute temperature

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W

⇒ The amount of time between the creation and disappearance of a hole in an intrinsic semiconductor material is called
life cycle
recombination time
life time
half life

⇒ Thevenin's equivalent circuit
can be drawn only in time domain
can be drawn only in frequency domain
can be drawn both in time and frequency domain
can be drawn in frequency domain with some restrictions

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ If F_n represents Fourier series coefficient of f(t), then Fourier series coefficient of f(t + t) =
F_ne ^-jω₀^t
F_ne ^jω₀^t
F_ne ^jnω₀^t
F_ne ^-jnω₀^t

⇒ Double integration of unit step function leads to
an impulse
a parabola
a ramp
a doublet

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ If the target area is small compared to wavelength of radar the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ Which of the following expressions is true for apparent power in an A.C. circuit?
VI cos Φ
V_av x I_av
V_r.m.s x I_r.m.s
V_peak x I_peak

⇒ A small signal source v_i(t) = A cos 20t + B sin10⁶t is applied to a transistor amplifier as shown below. The transistor has β = 150 and h_ie = 3 kΩ. Which expression best approximates V₀(t<
v₀(t) = -1500 (A cos 20t + B sin 10⁶t)
v₀(t) = -150 (A cos 20t + B sin 10⁶t)
v₀(t) = -1500 B sin 10⁶t
V₀(t) = -1500 sin 10⁶t

⇒
Match the following:
List I List II
A. p type semiconductor 1. silicon
B. n type semiconductor 2. holes are majority carriers
C. Intrinsic semiconductor 3. electrons are majority carriers
D. Tungsten 4. is a metal

A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-1, C-2, D-4

⇒ A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be
correlated
statistically independent
uncorrelated
orthogonal

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ A single phase full converter gives maximum and minimum output voltage at firing angles of
0 and 180° respectively
180° and 0° respectively
0 and 90° respectively
90° and 0° respectively

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒
Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.
Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°

⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ Which control action can never be used alone?
Proportional
Derivative
Integral
Both (b) and (c)

⇒ A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.
TRUE
FALSE

⇒ i₁(t) for t > 0 is give
2.5 - 2.5e^-2t
2.5 - 1.25e^-2t
1.25 - 1.25e^-2t
None of these

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ For the network shown below, determine f_Hi and f_HO, if, r₀ = ∞, C_be = 36 Pf, C_bc = 4 Pf, C_ce = 1 Pf, C_wo = 8 Pf, C_wi = 6 Pf<
738.24 KHz, 8.6 MHz
781.2 KHz, 10.6 MHz
838.32 KHz, 9.2 MHz
938.24 KHz, 8.2 MHz

	List I		List II
A.	p type semiconductor	1.	silicon
B.	n type semiconductor	2.	holes are majority carriers
C.	Intrinsic semiconductor	3.	electrons are majority carriers
D.	Tungsten	4.	is a metal

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math