Question is ⇒ In the 8421 BCD code, the decimal number 125, is written as, Options are ⇒ (A) 1111101, (B) 0001 0010 0101, (C) 7 D, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ In the 8421 BCD code, the decimal number 125, is written as, Options are ⇒ (A) 1111101, (B) 0001 0010 0101, (C) 7 D, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the 8421 BCD code, the decimal number 125, is written as
A.	1111101 [Correct Answer]
B.	0001 0010 0101 [Wrong Answer]
C.	7 D [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A transponder is a satellite equipment which
receives a signal from Earth station and amplifies
changes the frequency of the received signal
retransmits the received signal
does all of the above-mentioned functions

⇒ Internally the two distinct units of 8086 are called
bus interface unit and execution unit
command unit and follow unit
master unit and slave unit
memory unit and operation unit

⇒

Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops

Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In which n type device does p substrate extend upto silicon dioxide layer?
JFET
Depletion type MOSFET
Enhancement type MOSFET
Both (b) and (c)

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ The current I for the netw
0 mA
10.72 mA
10.94 mA
11.32 mA

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz
30, 60 and 70 kHz
3, 6 and 7 kHz
30, 60 and 70 MHz
3, 6 and 7 GHz

⇒

Assertion (A): A good op-amp should have very large band width

Reason (R): An ideal op-amp should have infinite input resistance and zero output resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The voltage multiplication is
25
50
125
250

⇒ Which of the following can be used to convert PPM into PWM?
Integrator
Astable multivibrator
Bistable multivibrator
Monostable multivibrator

⇒ The following graph, the number of trees (P) and the number of cut-sets (Q)
P = 2, Q = 2
P = 2, Q = 6
P = 4, Q = 6
P = 4, Q = 10

⇒ In a JFET
drain current is very nearly equal to source current
drain current is much less than source current
drain current may be equal to or less than source current
drain current may be even more than source current

⇒ If the ratio of ac to dc load impedance of a diode detector is low, the result will be
poor AGC operation
poor AF response
negative peak clipping
diagonal clipping

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40
4.878
1.212

⇒ Δ²V = - r/E is known as __________ equation
Poisson
Fourier
Laplace
Maxwell

⇒ Donor energy level is n type semiconductor is very near valence band.
TRUE
FALSE

⇒ A step up chopper can give an output voltage
higher than input voltage
lower than input voltage
both higher and lower input voltage
all of the above

⇒

Assertion (A): Derivative control action cannot be used alone.

Reason (R): Derivative control action is effective only during transient periods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The baud rate is
always equal to the bit transfer rate
equal to twice the bandwidth of an ideal channel
not equal to the signalling rate
equal to one half the bandwidth of ideal channel

⇒ 8255 A has three 8 bit ports A, B, C for peripheral data transfer. For programming 8255 A, these ports are grouped as
Port A with Port B
Port A with 4 most significant ports of C, port B with 4 least significant ports of C
Port A with Port C
none of the above

⇒

Assertion (A): Laplace transform of impulse function is equal to area under the impulse.

Reason (R): An impulse function whose area is unity is called unit impulse function.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The Causal system given below is _______
maximum phase
minimum phase
mixed phase
none of these

⇒ The most commonly used microphone for public address systems is
carbon
crystal
moving coil
condenser

⇒ The input and output of a continuous time system are respectively denoted by x(t) and y(t) Which of the following descriptions corresponds to a causal system?
y(t) = x(t - 2) + x(t + 4)
y(t) = x(t - 4) + x(t + 1)
y(t) = x(t + 4) + x(t - 1)
y(t) = x(t + 5) + x(t + 5)

⇒ Find the value of i_x if each resistance is of 3 Ω and each battery is of
1.1428 V
1.432 A
0.2892 A
O A

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ In the circuit of figure β = 50 and V_BE = 0.5 V. The quiescent value of base current I_{Babout 28 μA
about 28 mA
about 0.28 μA
about 2.8 A}

⇒ Two coupled coils lie in parallel planes such that 50% of magnetic flux produced by one links the other. The coefficient of coupling is
0.5
0.25
0.125
0.5