Question is ⇒ In TE10 mode of rectangular waveguide, Options are ⇒ (A) there is one half sine wave variation along x direction and one along y direction, (B) there is one half sine wave variation along y direction and one along x direction, (C) there is one full sine wave variation along x direction and one along y direction, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In TE10 mode of rectangular waveguide, Options are ⇒ (A) there is one half sine wave variation along x direction and one along y direction, (B) there is one half sine wave variation along y direction and one along x direction, (C) there is one full sine wave variation along x direction and one along y direction, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In TE₁₀ mode of rectangular waveguide
A.	there is one half sine wave variation along x direction and one along y direction [Correct Answer]
B.	there is one half sine wave variation along y direction and one along x direction [Wrong Answer]
C.	there is one full sine wave variation along x direction and one along y direction [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A land line telemetry system is suitable for distance upto
about 1 km only
about 10 km only
about 100 km only
any of the above

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ In a 4 bit ripple counter using flip flops with t_pd = 40 ns, the maximum frequency can be
1.25 MHz
3.25 MHz
6.25 MHz
12.5 MHz

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ In deriving ac equivalent circuit for an amplifier circuit we short circuit
all resistors
all transistors
all inductors
all capacitors

⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4

⇒ The function A e^st where s = s + jω represents
A phasor whose magnitude changes with time
A phasor whose frequency is ω
A phasor rotating in counterclockwise direction at angular frequency ω and whose magnitude increases with t
A phasor rotating in clockwise direction at angular frequency ω and whose magnitude increases with t

⇒ A 12 bit ADC is employed to convert an analog voltage of zero to 10 volts. The resolution of the ADC is
2.44 mV
24.4 mV
83.3 mV
1.2 V

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ In a parallel resonant circuit, the circuit current at resonance is maximum.
TRUE
FALSE

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr

⇒ In Java which operator can be used even if there is a single operand
+
-
*
%

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. when the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒

Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing.

Reason (R): During turn on the reverse biased junction in SCR breaksdown.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The maximum power that can be transferred to the load is resistor R_L from the voltage source in the figur
1 W
10 W
0.25 W
0.5 W

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ In drawing phasor diagram
rms values are used
peak values are used
either rms or peak values are used
either rms or peak or averages values are used

⇒ Armstrong modulator generates
AM signals
FM signals
PM signals
both (b) and (c)

⇒ The function shown in figure, can represent a probability density function for A ________
A = 1/4
A = 1/6
A = 1/8
A = 1/2

⇒ Operating point signifies that
zero signal I_C and V_BE
zero signal I_C and V_CE
zero signal I_B and V_CE
zero signal I_C, V_CE

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ In a triode
grid is nearer to cathode than anode
grid is nearer to anode than cathode
grid is equidistant from anode and cathode
any of the above

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In open circuit impedance parameters, the independent variables are
I₁ and I₂
V₁ and V₂
V₁ and I₁
V₂ and I₂

⇒ In the amplifier circuit figure the quiescent point voltage and current
12 V, 5 mA
12 V, 2 mA
10 V, 2 mA
10 V, 5 mA

⇒ VSB modulation is preferred in TV because
it reduces the bandwidth requirement to half
it avoids phase distortion at low frequencies
it results in better reception
none of the above

⇒ In 8085 microprocessor, in order to enable INTR interrupt, which of the following instruction are needed?
EI only
SIM only
El and SIM both
None

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ A transistor will operate in inverted region when
emitter junction is forward biased and collector junction is reverse biased
emitter junction is reverse biased and collector junction is forward biased
emitter junction as well as collector junction are forward biased
emitter junction as well as collector junction are reverse biased

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon