Question is ⇒ In TE and TM modes of rectangular waveguides having propagation in z direction, Options are ⇒ (A) Ez and Hz are both zero, (B) In TE mode Ez is zero and in TM mode Hz is zero, (C) In TE mode Hz is zero and in TM mode Ez is zero, (D) In both TE and TM modes both Ez and Hz are non-zero, (E) , Leave your comments or Download question paper.

Question is ⇒ In TE and TM modes of rectangular waveguides having propagation in z direction, Options are ⇒ (A) Ez and Hz are both zero, (B) In TE mode Ez is zero and in TM mode Hz is zero, (C) In TE mode Hz is zero and in TM mode Ez is zero, (D) In both TE and TM modes both Ez and Hz are non-zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In TE and TM modes of rectangular waveguides having propagation in z direction
A.	E_z and H_z are both zero [Wrong Answer]
B.	In TE mode E_z is zero and in TM mode H_z is zero [Correct Answer]
C.	In TE mode H_z is zero and in TM mode E_z is zero [Wrong Answer]
D.	In both TE and TM modes both E_z and H_z are non-zero [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit, V_s = 10 cos ωt, power drawn by the 4Ω resistor is 8 watt. The power facto
1
0.5
0.85
0

⇒ Two linearly polarized plane waves A and B travelling in free space in the positive x direction meet at a point. Wave A is polarized in the y direction and the wave B is polarized in the z direction. If the two waves are of equal amplitude and are in phase quadrature, the resultant wave will be
circularly polarized
elliptically polarized
linearly polarized
vertically polarized

⇒ In the given figure R_C = R_L = 1 kΩ, then V_{05 V
2.5 V
1 V
0 V}

⇒ The power factor at the input terminals of a cyclo- converter is generally
low and leading
low and lagging
high and leading
high and lagging

⇒ Linear transistor circuits always operate in
saturation region
cut off region
active region
passive region

⇒ Companding is used in PCM to
reduce bandwidth
increasing S/N ratio
get almost uniform S/N ratio
increase bandwidth

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
will increase
will decrease
will remain the same
may increase or decrease

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
786432 bits
648 bits
144 bits

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒ Dish antennas are
loop
helical
parabolic
conical

⇒ A 12 bit ADC is used to convert analog voltage of 0 to 10 V into digital. The resolution is
2.44 mV
24.4 mV
1.2 V
none of the above

⇒ Which one of the following can be used as parallel to series converter?
Decoder
Digital counter
Multiplexer
Demultiplexer

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ If a function f(t) is an odd, function, its Fourier series
contains only sine terms
contains only cosine terms
contains a constant and sine terms
contains a constant and cosine

⇒

Match the following:

	List I		List II
A.	Ring modulator	1.	Clock recovery
B.	VCO	2.	Demodulation of FM
C.	Foster Seeley discriminator	3.	Frequency conversion
D.	Mixer	4.	Summing of two points
		5.	Generation of FM
		6.	Generation of DSB-SC

A-1, B-3, C-2, D-4
A-6, B-5, C-2, D-3
A-6, B-1, C-3, D-2
A-5, B-6, C-1, D-3

⇒ In EPROM integrated dose is defined as
UV light intensity x exposure time in seconds
UV light intensity / exposure time in seconds
exposure time in seconds / UV light intensity
none of the above

⇒ The DTFT of x(n) = δ(n) will be
1
0
∞
not defined

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0

⇒ In a positive edge triggered JK flip flop, J = 1, K = 0 and clock pulse is rising Q will
be 0
be 1
show no change
toggle

⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
the polarity of voltage across R is same during discharge and during charge
the polarity of voltage across R during discharging is opposite to that during charging
the polarity of voltage across R depends on time constant RC
none of the above

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ When three 100 K, ± 10% fixed resistors of 1/4 W Power rating are connected in parallel, the resulting 33 K resistor will have a tolerance specification and power rating of
± 10% and 3/4 W respectively
± 10% and 1/12 W respectively
± 3.3.% and 3/4 W respectively
± 30% and 3/4 W respectively

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is
70.7 V
80.4 V
92.4 V
100 V

⇒ The number of address lines in EPROM 4096 x 8 is
2
4
8
12

⇒ In a triode the potential of grid (with respect to cathode) is usually
zero
negative
positive
zero or positive