Question is ⇒ In tape recorder erase head is active during recording., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In tape recorder erase head is active during recording., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In tape recorder erase head is active during recording.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Microprocessors find applications in
pocket calculators
scientific instruments
medical equipments
all of the above

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ In a loss-free R-L-C circuit the transient current is
oscillating
square wave
sinusoidal
non-oscillating

⇒ The amplitude of a random signal uniformly distributed between - 5 V and 5 V. If the positive values of the signal are uniformly quantized with a step size of 0.05 V, and the negative values are uniformly quantized with a step size of 0.10 V, the resulting signal to quantization noise is approximately
46 dB
43.8 dB
42 dB
40 dB

⇒ Polar plot of a lag-lead compensator is a circle.
TRUE
FALSE

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒ 300 to 3000 MHz frequency is categorized as
MF
HF
UHF
SHF

⇒ For a second order system, the position of poles is in the shaded region shown in the given figure. The variation in damping facto
from 0 to 1
from about 0.3 to 0.7
from 1 to 5
from 0 to 3

⇒ Which of the following array names is invalid in Fortran 77?
B(2, 4)
B(M, 3)
B(M, R)
B(3, 6)

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC

⇒ The design of wave filter is based on characteristic impedance which is
pure resistance
pure reactance
pure resistance in pass band and pure reactance in attenuation band
pure reactance in pass band and pure resistance in attenuation band

⇒ The velocity factor of a transmission line depends on
temperature
skin effect
relative permittivity of dielectric
none of the above

⇒ The most widely used LC oscillator is
Hartley oscillator
Crystal oscillator
Colpitt's oscillator
Clapp's oscillator

⇒ The HV supply to a TV receiver is 25 kV and the total beam current for the three electron guns is 2000 μA. The power handled by IHVT is
5W
0.5 W
50 W
500 W

⇒ The household radio receiver uses
synchronous
envelope detector
radio detector
none of the above

⇒ Chrome signals in PAL colour television system consist of
R - Y and B - Y signal
V and U signals
I and Q signals
R - Y and G - Y signals

⇒ In a carbon-zinc cell the function of the depolarizer is that
it synthesizes the decomposed electrolyte
it converts the produced hydrogen into water
it absorbs the oxygen produced in the cell
it prevents the fast chemical action on the zinc container

⇒ The V MOS can handle __________ currents than a conventional MOSFET.
much lower
almost same
almost half
much larger

⇒ Consider the following reasons for using antenna coupler

To prevent illegal radiation of spurious frequencies
To tune out reactive components of antenna impedance
To have correct value of load impedance for transmitter.

Which of the above are correct?
1, 2, 3
1, 2
1 only
2, 3

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ Which of the following ICs has only one NAND gate?
7410
7420
7430
7447

⇒ The product kT (where k is Boltzmann's constant and T is absolute temperature) at room temperature is about
0.051 eV
0.026 eV
0.01 eV
0.001 eV

⇒ Capture effect occurs in
AM
FM
PCM
QAM

⇒ For an RC driving point impedance function, the poles and zeros
should alternate on real axis
should alternate only on negative real axis
should alternate on imaginary axis
none of the above

⇒ The operations which occur most frequently in a computer are
fetch
execute
both (a) and (b)
none of the above

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these