Question is ⇒ In super computers the extra level of primary memory is generally called, Options are ⇒ (A) Solid state device, (B) Single stage device, (C) Digital state device, (D) Surface stage device, (E) , Leave your comments or Download question paper.

Question is ⇒ In super computers the extra level of primary memory is generally called, Options are ⇒ (A) Solid state device, (B) Single stage device, (C) Digital state device, (D) Surface stage device, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In super computers the extra level of primary memory is generally called
A.	Solid state device [Correct Answer]
B.	Single stage device [Wrong Answer]
C.	Digital state device [Wrong Answer]
D.	Surface stage device [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The value of program counter of 6800 at power on are after reset is
0
FFFE
User Programmable
FFFF

⇒ If 10 V is the peak voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit), then the maximum voltage on the reverse biased diode will be
20 V
14.14 V
10 V
7.8 V

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after CMA?
6 AH, 1
6 AH, 0
59 H, 0
9 H, 0

⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V₀
49 mV
51 mV
48 mV
45 mV

⇒ In the above case the modulation index will be
9.6
28.8
57.6
100

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)

⇒ Tropospheric mode of propagation is used in
UHF
VLF
MF
HF

⇒ Which inverter circuit uses coupled inductors?
Modified McMurray full bridge inverter
McMurray Bedford half bridge inverter
Modified McMurray Bedford half bridge inverter
Both (b) and (c)

⇒ The affect of ground on radiation pattern is to
cause cancellation of radiation along the ground
produce more number of nulls
both (a) and (b)
either (a) or (b)

⇒ When two port networks are connected in cascade, it is more convenient to use hybrid parameters.
TRUE
FALSE

⇒ The characteristics of a non-linear resistance is i = kv⁴. If i becomes 100 times, v becomes
about 100 times
about 10 times
about 3 times
about twice

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ In an n channel MOSFET, the substrate is connected
to negative terminal of battery
to positive terminal of battery
to either positive or negative terminal of battery
none of the above

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open

⇒ Mutual impedance is not depend upon
magnitude of induced current
tuning condition
self impedance
phase relationship between induced and original currents

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒ Calculate i(t) for t ≥ 0, assuming the switch has been in position A for a long time at t = 0, the switch is moved to positio
1 + e^{-5 x 10³t}
e^{-5 x 10³t}
1.11 e^{-5 x 10³t}
1.11 (1 - e^{-5 x 10³t})

⇒ Which of the following can provide two or more voice circuits with the same carrier?
SSB
Carrier reinsertion
Lincompex
Independent side band system

⇒ If the value of C₂ and C₃ are doubled, the oscillation frequency will be
quadrupled
doubled
unchanged
halved

⇒ CATV stands for
Common Antenna Television
Community Antenna Television
Cable Antenna Television
Channel Antenna Television

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.
TRUE
FALSE

⇒ The relation between the apparent power, actual power and reactive power is given by
Apparent power = actual power + reactive power
Apparent power = actual power - reactive power
Apparent power = (actual power)² - (reactive power)²
Apparent power = (actual power)² + (reactive power)²

⇒ An ac network has a power factor of 0.8 leading if the applied wave is of fundamental frequency. If the applied wave contains third and fifth harmonics, the overall power factor will be
0.8 leading
less than 0.8 leading
more than 0.8 leading
0.8 leading or more

⇒ Pick the odd one
variance
standard deviation
expectation
chebyshev inequality

⇒ Energy density function is always
even
odd
neither even nor odd
both (a) and (b)

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr