Question is ⇒ In static RAM 6264 the number of address inputs are, Options are ⇒ (A) 10, (B) 12, (C) 13, (D) 15, (E) , Leave your comments or Download question paper.

Question is ⇒ In static RAM 6264 the number of address inputs are, Options are ⇒ (A) 10, (B) 12, (C) 13, (D) 15, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In static RAM 6264 the number of address inputs are
A.	10 [Wrong Answer]
B.	12 [Wrong Answer]
C.	13 [Correct Answer]
D.	15 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Parallel wire transmission line is an example of
lumped network
distributed
depend upon I/P signal strength
power I/P

⇒ Which of the following is the main difference between waveguide and transmission line?
Waveguides cannot be coupled to coaxial lines
Waveguides have no standing wave ratio
Transmission line does not suffer from the effect of low cut off frequency
Waveguides are not distributed like transmission lines

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ In a bipolar transistor, the emitter base junction has
forward bias
reverse bias
zero bias
zero or reverse bias

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V₀/V_i should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ In a network containing resistances, reactances the root of the characteristic equation give for the circuit
the forced response
the total response
the natural response
the damped response

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ The total lumens emitted by a source of 1 candle are
0.4 p
4 p
2 p
8 p

⇒ A pure tone at 1000 Hz has a dB level of 50 dB. If two such tones exist simultaneously the dB level is about
50 dB
53 dB
100 dB
200 dB

⇒ The closing of switch S₁ and S₂ in figure will ligh
lamp L₁ only
lamps L₁ and L₂
none of them
lamp L₂ only

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ Find the maximum power that can be delivered to a
0.025 W
2.5 W
2.5 W
0.25 W

⇒ If a RAM has 34 bits in its MAR and 16 bits its MAR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ A computer program is used to read M and print the sum 2 + 4 + 6 + 8 +.........+ 2M. If M = 9 , the print out will show the number
9
18
90
100

⇒ A circuit which cannot demodulate SSB is
balanced modulator
product detector
BFO
phase discriminator

⇒ Wire-wound resistors are unsuitable for use at high frequencies because they
are likely to melt under excessive eddy current heat
exhibit unwanted inductive and capacitive effects
create more electrical noise
consume more power

⇒ The sensitivity of a voltmeter using 0-5 mA meter movement is
50 Ω/V
100 Ω/V
200 Ω/V
500 Ω/V

⇒ An RC circuit initially at rest has a step signal. The response V(t) across C is V(t) = 1 - e^-at, If now there is an initial voltage on C of 2 volts for the same step signal, V(t) is now
1 + e ^-at
1 + 2e ^-at
2 - e ^-at
3 - e ^-at

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒ The minimal function that can detect a "divisible by 3" 8421 BCD code digit (representation D₈D₄D₂D₁) is given by
D₈D₁ + D₄D₂ + D₈D₂D₁
D₈D₁ + D₄D₂ D₁ + D₄D₂D₁ + D₈D₄D₂D₁
D₄D₁ + D₄D₂ + D₈D₄ D₂D₁
D₄D₂D₁ + D₄D₂D₁ + D₈D₄D₂D₁

⇒ The maximum phase difference between the applied voltage and current in a RLC series current with finite values of R, L, C, and f can be
less than 90°
less than 45°
180°
30°

⇒ The linear transistor circuits always operate in the
saturation
cut off
active
inactive

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ In common base connection, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_C and V_CE
I_E and V_CB
I_E and V_CE

⇒ In a superheterodyne receiver, having no RF amplifier, the IF is 455 kHz. The image frequency at 1000 kHz is
1455 kHz
545 kHz
1910 kHz
90 kHz

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ Specific resistance of silver is about
0.16 x 10^-8 Ω-m
1.64 x 10^-8 Ω-m
16 x 10^-8 Ω-m
164 x 10^-8 Ω-m