Question is ⇒ In <span class="symbol">p</span> mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to, Options are ⇒ (A) one pole/cycle, (B) two pole/cycle, (C) four pole/cycle, (D) six pole/cycle, (E) , Leave your comments or Download question paper.

Question is ⇒ In <span class="symbol">p</span> mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to, Options are ⇒ (A) one pole/cycle, (B) two pole/cycle, (C) four pole/cycle, (D) six pole/cycle, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In p mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to
A.	one pole/cycle [Wrong Answer]
B.	two pole/cycle [Correct Answer]
C.	four pole/cycle [Wrong Answer]
D.	six pole/cycle [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Expression ++i is equivalent to
i = i + 2
i = i + 1
i = i - 1
i = i + i + i

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒ A class B chopper operates in third quadrant.
TRUE
FALSE

⇒ Which of the following 8 bit microprocessors has maximum addressing modes?
8085
Z 80
6800
6809

⇒ Integrated fin line can be utilized as a medium for constructing millimeter wave circuits.
TRUE
FALSE

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9

⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0
e^as F(s)
e^-as F(s)
- e^as F(s)
- e ^-as F(s)

⇒ The pure capacitor connected across an A.C. voltage consumed 20 W. This is due to
the capacitive reactance in ohms
the current flowing in the capacitor
the fused capacitor was a big one
none of the above

⇒ In an air cored coil, a current of 0.7 A causes a flux of 5 x 10^-6 Wb. If the core is made of cast iron and the coil is similar, the same current can set up a flux of about
5 x 10^-6 Wb
5 x 10^-8 Wb
10^-2 Wb
5 x 10^-4 Wb

⇒ For the output F to be 1 in the logic circuit shown, the input combination shoul
A = 1, B = 1, C = 0
A = 1, B = 0, C = 0
A = 0, B = 1, C = 0
A = 0, B = 0, C = 1

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²

⇒

Assertion (A): Thermocouple instruments can be used for ac only.

Reason (R): Thermocouple instrument has a non linear scale.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For a = - 1, find the value of V_{2∞
0
V₁
none of the above}

⇒ In figure the collector to emitter breakdown voltage of the transistor (βV_CEO) shoul
more than V_CC
more than 0.5 V_CC
more than V_CC + E
more than 2 V_CC

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ For AB + A C + BC = AB + A C the dual form is
(A + B) (A + C)(B + C) = (A + B)(A + C)
(A + B ) (A + C)(B + C) = (A + B)(A + C)
(A + B) (A + C) (B + C) = (A + B) (A + C)
none of the above

⇒ Pagemaker is an application software for DTP.
TRUE
FALSE

⇒ A mode-10 counter can divide the clock frequency by a factor of
10
100
1000
10000

⇒ To find the current in a 20 Ω resistance connected in a circuit, Norton's theorem is used. I_N = 7.5 A. The current though 20 Ω resistance.
is 7.5 A
is less than 7.5 A
may be 7.5 A or less
may be 7.5 A or more or less

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ Consider the following program for 8085 Adds decimal number 5 to contents of memory
Subtracts decimal number 5 from contents of memory
Subtracts decimal number 15 from contents of memory
Adds decimal number 15 to contents of memory

⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs

⇒ If Y(s) = 1 + s, the network has
1 Ω resistor and 1 F capacitor in series
1 Ω resistor and 1 F capacitor in parallel
1 Ω resistor and 1 H inductor in series
1 Ω resistor and 1 H inductor in parallel

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒

Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index m_t
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V₀/V_i should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF

⇒ In a CE amplifier the input impedance is equal to the ratio of
ac base voltage to ac base current
ac base voltage to ac emitter current
ac emitter voltage to ac collector current
ac collector voltage to ac collector current

⇒

Assertion (A): The colour signal consists of only luminance signal

Reason (R): In India PAL colour signal system is used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct