Question is ⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are, Options are ⇒ (A) electronic only, (B) electronic and ionic, (C) electronic, ionic and permanent, (D) electronic and permanent, (E) , Leave your comments or Download question paper.

Question is ⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are, Options are ⇒ (A) electronic only, (B) electronic and ionic, (C) electronic, ionic and permanent, (D) electronic and permanent, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In solid insulator materials having only one kind of atom, the types of polarization which exist are
A.	electronic only [Correct Answer]
B.	electronic and ionic [Wrong Answer]
C.	electronic, ionic and permanent [Wrong Answer]
D.	electronic and permanent [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A duplexer is a device used to
feed more than one receiver from a single antenna
connect two transmitters to the same antenna
connect a receiver and a transmitter to the same antenna
none of these

⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of
10°C
25°C
50°C
75°C

⇒ As compared to MOS memories, bipolar memories have
slower access time but are cheaper
slower access time and are costly
faster access time and are cheaper
faster access time and are costly

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600
-600 V
Zero
600 V
1200 V

⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has directivity of 100 is
15.92
31.84
2.18
3.184

⇒ For a BJT, under the saturation region.
I_C = βI_B
I_C > βI_B
I_C is independent of other parameter
I_C < βI_B

⇒ The signals in 8086 are classified into
minimum mode and maximum mode
decrement mode and increment mode
low mode and high mode
none of the above

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
- sin ω₁t + cos ω₂t

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒ A 4 bit down counter can count from
0000 to 1111
1111 to 0000
000 to 111
111 to 000

⇒ The characteristic equation of a control system is given as s⁴ + 8s³ + 24s² + 32s + K = 0. What is the range of values of K for this system to be stable?
0 ≤ K < 80
0 ≤ K < 100
0 ≤ K < 2300
0 ≤ K < 600

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ In control systems the magnitude of error voltage
is very small
is very large
neither small nor large
may be any value from 0 to 50 V

⇒ Resistivity of copper is nearly
1.56 μ ohm-cm
3.95 μ ohm-cm
14.55 μ ohm-cm
22.05 μ ohm-cm

⇒ In which of the following logical group instructions of 8085 is the addressing mode 'immediate'?
ANA r
ANA M
ANI data
XRA r

⇒ Radar reciever has high sensitivity and low noise figure
TRUE
FALSE

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒ For a plane good conductor, skin depth varies
directly as square root of permeability
directly as square root of frequency
inversely as permittivity
inversely as square root of conductivity

⇒ Which one is correct option?

A pure capacitor never dissipates energy, but only stores.
Capacitor can store finite amount of energy even cunent is zero.
The current through a capacitor is zero if voltage across it d.c.
Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
q_c(0^-) = q_c(0⁺)

5, 4, 3, 2
3, 4, 1, 2
2, 4, 3, 1
1, 2, 3, 4, 5

⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A
both the average and rms thyristor currents will be less than 20 A
both the average and rms thyristor currents will be more than 20 A
rms thyristor current will be 20 A and average thyristor current will be 10 A

⇒ For the time domain response shown in figure the
lies in left half plane
lies on imaginary axis
lies along the positive real axis
may be complex or imaginary

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ The spins in a ferrimagnetic material are
all aligned parallel
partially aligned antiparallel without exactly cancelling out sublattice magnetisation
randomly oriented
all aligned antiparallel such that the sublattice cancels out exactly

⇒ During induction heating of metals which of the following is abnormally high?
Frequency
Voltage
Current
Power factor

⇒

Assertion (A): Wien bridge can be used for measuring frequency.

Reason (R): A frequency meter for 50 Hz system has a frequency range of 40 to 60 Hz.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ The cascade amplifier is a multistage configuration of
CC-CB
CE-CB
CB-CC
CE-CC