Question is ⇒ In single tone AM modulation, the transmission efficiency for <i>m</i> = 1 is, Options are ⇒ (A) 0.333, (B) 0.5, (C) 1, (D) 0.1665, (E) , Leave your comments or Download question paper.

Question is ⇒ In single tone AM modulation, the transmission efficiency for <i>m</i> = 1 is, Options are ⇒ (A) 0.333, (B) 0.5, (C) 1, (D) 0.1665, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In single tone AM modulation, the transmission efficiency for m = 1 is
A.	0.333 [Correct Answer]
B.	0.5 [Wrong Answer]
C.	1 [Wrong Answer]
D.	0.1665 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Norton's equivalent circuit
is same as Thevenin's circuit
has no relation with Thevenin's circuit
is dual of Thevenin's circuit
is reciprocal of Thevenin's circuit

⇒ The converter whose conversion time is independent of number of bits is
dual stope
counter type
parallel conversion
successive approximation

⇒ A square in which each (i, j)^th element of matrix is equal to the negative of the conjugate complex of (j, i)^th element, is called
Hermitian matrix
Skew symmetric matrix
Conjugate anti-symmetric matrix
Skew-Hermitian matrix

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ Consider the following statements

Tellegen's theorem is applicable to any lumped network.
Reciprocity theorem is applicable to linear bilateral network.
Thevenin theorem is applicable to two terminal linear active network.
Norton's theorem is applicable to linear active network.

Which of the above statements are correct?
1, 2 and 3
1, 2, 3 and 4
1, 2 and 4
3 and 4

⇒ In a photo emissive device and emission efficiency is increased by
coating the cathode ray by an active materials
coating the cathode by an insulating material
heating the cathode
cooling the anode

⇒ For the network in figure, the correct loop equation for loop
-I₁ + 4I₂ + 11I₃ = 0
I₁ + 4I₂ + 11I₃ = 0
-I₁ - 4I₂ + 11I₃ = 0
I₁ - 4I₂ + 6I₃ = 0

⇒ If sound wave has an intensity of 10 Pa. The dB level is about
1.139 dB
11.39 dB
113.9 dB
1139 dB

⇒ The voltage applied to an R-L circuit at t = 0 when switch is closed is 100 cos (100 t + 30°). The circuit resistance is 80 Ω and inductance is 0.6 H (in which initial current is zero). What is the maximum amplitude of current flowing through the circuit?
0.0416666666666667
0.0833333333333333
0.208333333333333
0.416666666666667

⇒ In figure, the current supplied by battery at t = 0.5s1.1 A
1.9 A
0
1.632 A

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of V_s. What will be circuit voltage gain for + V_s and for - V_s if D₂ is id
A_V = -R₃/R₁
R₃/R₁
R₁/R₃
1 + R₃/R₁

⇒ Which one is discrete time periodic signal?
sin 3pn
cos 2pn
sin 3pn
all

⇒ A parallel resonant circuit can be used
as a high impedance
to reject a small band of frequencies
both (a) and (b)
to amplify certain frequencies

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ The transfer function G₁₂ (s) for a two port is
V₂/V₁
V₂ (s)/V₁ (s)
V₂ (s)/I₁ (s)
I₂ (s)/I₁ (s)

⇒ The input gate current of FET is closer to
few amperes
few milli amperes
few microamperes
negligibly smaller value

⇒ If current is less than 20 mA and time of contact is very small, the effect of current on human body is likely to be temporary.
TRUE
FALSE

⇒ To separate channels in FDM receiver we have to use
integration
AND gate
band pass filter
differentiation

⇒ The material used for the magnet of moving coil cone type loudspeaker is
steel alloy
soft iron
hard steel
Alnico

⇒ The expression given is F(A, B, C, D, E, F, G, H) = Σ(33, 48, 102, 158, 222, 229, 233, 243, 255); then the __________ and __________ minterms are grouped together into dual and variable __________ is reduced using the dual
243, 233, D
222, 158, B
243, 255, A
229, 243, E

⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt² is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2

⇒ How many flag are there in 8085 microprocessor?
4
5
6
8

⇒ Circuit shown in the figur
astable multivibrator
monostable multivibrator
VCO
ramp Generator

⇒ Which of the following modulation is analog in nature?
PCM
DPCM
DM
PDM

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒
Assertion (A): Helium, Argon and Neon are gaseous at room temperature.
Reason (R): The atoms in Helium, Argon and Neon are chemically extremely inactive.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ For frequency up to 1650 kHz, the transmitting antenna is used a
parabolic dish
vertical antenna
yagi antenna
turnstile antenna

⇒ Consider the following statements regarding electro-dynamometer type indicating instrum
1 and 2 are corect
3 and 4 are correct
1 and 3 are correct
1, 2, 3, 4 are correct

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math