Question is ⇒ In single phase half wave regulator, the average current over one full cycle, Options are ⇒ (A) is always positive, (B) may be positive or negative, (C) may be negative, (D) is always negative, (E) , Leave your comments or Download question paper.

Question is ⇒ In single phase half wave regulator, the average current over one full cycle, Options are ⇒ (A) is always positive, (B) may be positive or negative, (C) may be negative, (D) is always negative, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In single phase half wave regulator, the average current over one full cycle
A.	is always positive [Wrong Answer]
B.	may be positive or negative [Wrong Answer]
C.	may be negative [Wrong Answer]
D.	is always negative [Correct Answer]
View Answer 1 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The signal defined by the equations f(t) = 0 for t < 0, f(t) = E for 0 ≤ t ≤ a and f(t) = 0 for t > a is
a step function
a pulse function
a shifted step function originating at t = a
none of the above

⇒ A pure tone at 1000 Hz has a dB level of 50 dB. If two such tones exist simultaneously the dB level is about
50 dB
53 dB
100 dB
200 dB

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ If the number of atoms per unit volume of a monoatomic gas changes, the dielectric constant still remains constant.
TRUE
FALSE

⇒ In figure V_BE = 0.7 V. If base current required to saturate the transistor is 0.1 mA, V_{i5 V
5.7 V
10 V
10.7 V}

⇒ The voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit) is 25 volts. The maximum voltage on the reverse biased diode will be
100 V
50 V
25 V
12.5 V

⇒ A nibble corresponds to
2 successive bits of data
4 successive bits of data
8 successive bits of data
16 successive bits of data

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒

Assertion (A): For a physically realisable driving point function, the degree of numerator and denominator should be equal.

Reason (R): The sum of positive real functions is real.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Using 4-bit numbers (n = 4) if k = (0011)₂ how is k expressed in 2's complement.
(1011)₂
(1101)₂
(1100)₂
(0101)₂

⇒ A CE amplifier is the most common BJT amplifier.
TRUE
FALSE

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ Consider the following, logic diagr
0000 to 1111
0000 to 1001
0000 to 1010
1001 to 0000

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ The number of inputs and outputs in a full adder are
2 and 1
2 and 2
3 and 3
3 and 2

⇒ Which of the following statement is correct?
The input impedance of CE amplifier is usually around 10 Ω
The voltage gain of a transistor amplifier in CE mode is always less than unity
The output impedance of a transistor amplifier is independent of the transistor configuration
The voltage gain of a transistor amplifier is independent of the load resistance

⇒ The amplifier used in bootstrap voltage sweep should have a gain of
1
+∞
-1
-∞

⇒ Poynting vector is the rate of energy flow having
W/m²
W-m
kWh/s
W/m

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ For resonant long wire antenna 'n' half wavelength long in free space, if 'n' is increased then inclination of the major lobe with wire axis will __________ .
increases
decreases
remains same
none

⇒ The noise sources shot noise, partition noise and thermal noise are associated with which component
BJT
diode
resistor
capacitor

⇒ Consider an input x(t) as sh
-2 < t < 6
0 < t < 11
-2 < t < 5
2 < t < 6

⇒ Permeability is analogous to
resistivity
retentivity
conductivity
coercivity

⇒ The resistance of a 125 Ω strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is
1.5
2
2.5
3

⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
5/δ
Intermediate
δ/5
δ

⇒ The absolute values of pinch-off voltage and gate-source cut-off voltage are
nearly zero
complementary to each other
never equal
equal

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD

⇒ When a normal atom loses an electron
the atom loses one-proton simultaneously
rest of the electrons move faster
the atom becomes a positive ion
the atom becomes a negative ion