Question is ⇒ In selecting a satellite system, the First determining factor is its, Options are ⇒ (A) EIRP, (B) antenna size, (C) coverage a sea, (D) antenna gain, (E) , Leave your comments or Download question paper.

Question is ⇒ In selecting a satellite system, the First determining factor is its, Options are ⇒ (A) EIRP, (B) antenna size, (C) coverage a sea, (D) antenna gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In selecting a satellite system, the First determining factor is its
A.	EIRP [Wrong Answer]
B.	antenna size [Wrong Answer]
C.	coverage a sea [Correct Answer]
D.	antenna gain [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ In a clocked latch, clock drives
R NAND gate
S NAND gate
both R and S NAND gates
either R or S NAND gates

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ In a simple on-off controller with differential gap, the magnitude of differential gap determines
the level of accuracy
the life of controller
both (a) and (b)
neither (a) nor (b)

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then R_{B200 kΩ
265 kΩ
150 kΩ
100 kΩ}

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒

Assertion (A): The angular momentum of an atom is due to three contributions viz. orbital, electron spin and nuclear spin.

Reason (R): The nuclear spin magnetic moment is much more than electron spin magnetic moment.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ When a lead acid cell is in fully charged condition the positive and negative plates are similar.
TRUE
FALSE

⇒ The minimum permissible size of aluminium cable for lighting circuit is
1.2 sq. mm
1.5 sq. mm
2.2 sq. mm
3.5 sq. mm

⇒ Which one of the following is a trivalent material?
Antimony
Phosphorus
Arsenic
Boron

⇒ A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is
300 mW
330 mW
350 mW
380 mW

⇒ Which of the following array names in Fortran 77 is invalid?
A(6)
A(R)
A(I)
A(N)

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
very low
low
high
almost zero

⇒ For a MOD-12 counter, the FF has a t_pd = 60 ns The NAND gate has a t_pd of 25 n sec. The clock frequency is
3.774 MHz
> 3.774 MHz
< 3.774 MHz
4.167 MHz

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ In a rectangular waveguide cutoff wavelength for TE₁₀mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is
8 cm
6 cm
4 cm
2 cm

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ Almost all high level languages have provision for logical operations.
TRUE
FALSE

⇒ An amplifier signal is made up of just two frequencies 1000 Hz. The output signal consists of 500 Hz and 25000 Hz frequencies. This may be attributed to
harmonic distortion
intermodulation distortion
both (a) and (b)
none of the above

⇒ In CE amplifier the base current is very high.
TRUE
FALSE

⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt² is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2

⇒ Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?
Tilting
Loss of line-of-eight conditions
Interference from the sky wave
Maximum single hop distance limitation

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ Negative feedback lowers the cut off frequency and increase the upper cut off frequency of amplifier.
TRUE
FALSE

⇒

Assertion (A): Points in the s plane at which function G(s) is not analytic are called singular, points.

Reason (R): Singular points at which the function G(s) or its derivative approach infinity are called poles.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): The resistivity of intrinsic semiconductor decreases with increase in temperature.

Reason (R): The forbidden gap decreases with increase in temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true