Question is ⇒ In practical commercial FM system, channel bandwidth is, Options are ⇒ (A) 150 kHz, (B) 100 kHz, (C) 88 MHz, (D) 108 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ In practical commercial FM system, channel bandwidth is, Options are ⇒ (A) 150 kHz, (B) 100 kHz, (C) 88 MHz, (D) 108 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In practical commercial FM system, channel bandwidth is
A.	150 kHz [Correct Answer]
B.	100 kHz [Wrong Answer]
C.	88 MHz [Wrong Answer]
D.	108 MHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The divergence of a vector is a scalar, while the curl of a vector is another
scalar
vector
unit vector
none of the above

⇒

Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ It is necessary to measure the amplitudes of two signals and also the phase difference between them. This can be done by using a
phase meter
waveform meter
vector voltmeter
digital voltmeter

⇒ A series R, L, C circuit has R = 2Ω, L = 1H, C = 1 μF. It is connected to an ac variable frequency source of peak voltage 10 V. At resonance the power supplied by the source will be
50 Ω
25 Ω
12.5 Ω
6.25 Ω

⇒ If a sound wave has a frequency of 50 Hz, the wavelength is
66 m
6.6 m
0.66 m
0.066 m

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ In a hi-fi system the frequency response over the audio frequency range should be within
± 10 dB
5 dB
2 dB
1 dB

⇒ A LASCR has
4 semiconductor layers and 3 junctions
3 semiconductor layers and 2 junctions
2 semiconductor layers and 2 junctions
any of these depending on the rating

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ A rare gas having N atoms/m³ is subjected to an electric field E. The electric dipole moment per unit volume is proportional to N and E.
TRUE
FALSE

⇒ The dc load current in a bridge rectifier circuit is 10 mA. The dc load current through each diode is
40 mA
20 mA
10 mA
5 mA

⇒ Indium, aluminium, arsenic are all p type impurities.
TRUE
FALSE

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ The units of thermal capacitance are
k cal/°C
°C/k cal
°C sec/k cal
none of the above

⇒ When .9432 E - 4 is subtracted from .5452 E - 3 in normalized floating point mode
none of the numbers is changed
.9432 E - 4 is changed to .09432 E - 3 and .5452 E - 3 is not changed
.5452 E - 3 is changed to 5.452 E - 4 but .9432 E - 4 is not changed
both Ihe numbers are changed and their exponents are, made equal to -5

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ Consider the following statements:

Acceptor level is formed very close to the conduction band.
The effective mass of the free electron is same as that of a hole.
The magnitude of the charge of a free electron is same as that of a hole.
Addition of donor impurities adds holes to the semiconductor.

Which of the above statements are correct?
1 and 3
2 and 3
2 and 4
3 and 4

⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE

⇒ Which one is correct statement?

Circuit is always open
Network is always open
Circuit is always closed
Network is always closed

1, 2
2, 3
3, 4
1, 4

⇒ A thermal power plant has an efficiency of 0.4. If 0.6 kg of coal is burnt to generate 1 kWh, the calorific value of coal is
about 3500 kcal/kg
about 2500 kcal/kg
about 1500 kcal/kg
about 7500 kcal/kg

⇒

Assertion (A): JFET is a voltage controlled device.

Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron
will be increased
will be decreased
will remain the same
either (a) or (b)

⇒ In Java 31% gives an answer
3
4
42798
42828

⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V

⇒ When two ALU 1C 74181 are cascaded
the carry out of first stage is connected to carry in of second stage
the carry in of first stage connected to carry in of second stage
the carry in of first stage is connected to carry out of second stage
the carry out of first stage is connected to carry out of second stage

⇒ Which of the- following display consumes least amount of power?
LCD
LED
Fluorescent display
All display consume same power

⇒

Assertion (A): If A = 0.5 ∠ 20°, A² = 0.25 ∠ 40°.

Reason (R): When drawing a phasor diagram, sinusoids may have the same or different frequencies.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true