Question is ⇒ In practical commercial AM system channel bandwidth is, Options are ⇒ (A) 150 kHz, (B) 100 kHz, (C) 15 kHz, (D) 200 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ In practical commercial AM system channel bandwidth is, Options are ⇒ (A) 150 kHz, (B) 100 kHz, (C) 15 kHz, (D) 200 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In practical commercial AM system channel bandwidth is
A.	150 kHz [Wrong Answer]
B.	100 kHz [Wrong Answer]
C.	15 kHz [Correct Answer]
D.	200 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒

Match the following:

	List I (Instrument)		List II (Parameters)
A.	Moving coil galvanometer	1.	High inertia, soft spring control
B.	Ballistic galvanometer	2.	No control, high damping
C.	Vibration galvanometer	3.	Soft spring control, critical damping
D.	Moving coil flux meter	4.	Low inertia, tuned spring control

A-4, B-2, C-3, D-1
A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ Materials in order of decreasing electrical conductivity are
aluminium, silver, gold, copper
gold, silver, copper, aluminium
copper, silver, gold, aluminium
silver, copper, gold, aluminium

⇒ If an inductance L is connected in one arm of bridge and resistance R₁, R₂, R₃ in other three arms
the bridge cannot be balanced
the bridge can be balanced
the bridge is balanced for some specified value of frequency
the bridge is balanced for some specific values of R₁, R₂, R₃

⇒ As the number of flip flops are increased, the total propagation delay of
ripple counter increases but that of synchronous counter remains the same
both ripple and synchronous counters increase
both ripple and synchronous counters remain the same
ripple counter remains the same but that of synchronous counter increases

⇒ In which of the following semiconductor are holes minority carriers
extrinsic
p type
n type
intrinsic

⇒ The r_e model equivalent circuit shown in figure is
CE amplifier
CC amplifier
CB amplifier
None of the above

⇒ Lead becomes a superconductor at
9.1 K
7 K
5 K
3 K

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ Which of the following amplifier circuits has highest input impedance?
Circuit using BJT
Circuit using JFET
Circuit using MOSFET
Either (a) or (b)

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ If a two-port network is reciprocal as well as symmetrical, which one of the following relationships is correct?
Z₁₂ = Z₂₁ and Z₁₁ = Z₂₂
Y₁₂ - Y₂₁ and Y₁₁ - Y₂₂
AD - BC = 1 and A = D
all of the above

⇒ Find equivalent resistance. Each resistance is l &Om
5/12 Ω
5/6 Ω
6/5 Ω
6/10 Ω

⇒ Skip distance depends on time of day and angle of incidence.
TRUE
FALSE

⇒ The PAM Signal can be detected by
Band pass filter
Band stop filter
High pass filter
Low pass filter

⇒ Under identical conditions, for a single modulating frequency, FM and PM are indistinguishable. Now if the modulating frequency is reduced, then
phase modulation index as well as frequency modulation index decrease
phase modulation index as well as frequency modulation index increase
phase modulation index will remain constant whereas frequency modulation index will increase
phase modulation index will decrease whereas frequency modulation index will remain constant

⇒ If transfer function of a system is H(z) = 6 + z^-1 + z^-2 then system is
minimun phase
maximum phase
mixed phase
none

⇒ If a linear time invartant system is exicited by a pure random signal like white noise, the output of the linear system will have which of the following properties?
Output will be a white noise
Output will be periodic
Output will be random
Output will be correlated or coloured noise

⇒ For oscillations to starts, the loop gain A β of the oscillator must be initially
less than unity
0.5
1
more than unity

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ In the circuit shown in the given figure, power dissipated in the 5 Ω resisto
zero
80 W
125 W
405 W

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ The analog signal given below is sampled by 600 samples per second for m(t) = 3 sin 500 pt + 2 sin 700 pt then folding frequency is
500 Hz
700 Hz
300 Hz
1400 Hz

⇒ Loss of charge method is suitable for medium resistances.
TRUE
FALSE

⇒ In a colour TV receiver AFT stands for
Automatic Fine Tuning
Automatic Frequency Tuning
Automatic Field Tuning
Alignment Frequency Tuning

⇒ A Darlington circuit is obtained by connecting
two CB stages in cascade
two CE stages in cascade
a CE stages followed by CB stage
two emitter follower in cascade

⇒ The sensitivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D