Question is ⇒ In PCM, the information lies, Options are ⇒ (A) in one or two properties of the pulse, (B) in absence of pulse, (C) in presence of pulse, (D) in presence or absence of pulse, (E) , Leave your comments or Download question paper.

Question is ⇒ In PCM, the information lies, Options are ⇒ (A) in one or two properties of the pulse, (B) in absence of pulse, (C) in presence of pulse, (D) in presence or absence of pulse, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In PCM, the information lies
A.	in one or two properties of the pulse [Wrong Answer]
B.	in absence of pulse [Wrong Answer]
C.	in presence of pulse [Wrong Answer]
D.	in presence or absence of pulse [Correct Answer]
View Answer 1 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒

Assertion (A): A PROM can be used as a synchronous counter

Reason (R): Each memory location in a PROM can be read synchronously.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A 3 bit up-down counter can count from
000 to 111
111 to 000
000 to 111 and also from 111 to 000
none of the above

⇒ Which chopper circuit operates in quadrants 1 and 4?
A
B
D
E

⇒ In filter system of sideband suppression the advantage of using mechanical filter is
smaller size
good bandpass
good attenuation characteristics
all of the above

⇒ A message signal x(t) is amplitude modulated with carrier c(t2ω
3ω
1ω
0.5ω

⇒ In the balanced bridge shown in figure. X should
a self inductance having resistance
a capacitance
a non-inductive resistance
an inductance and capacitance in parallel

⇒ Microprocessors find applications in
pocket calculators
scientific instruments
medical equipments
all of the above

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒ In figure gain bandwidth produc
200 Hz
200 MHz
200 kHz
2 MHz

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒ A divide by 78 counters can be realized by using
six mod-13 counters
thirteen mod-6 counters
one mod 13 counter followed by one mod-6 counter
thirteen mod-13 counters

⇒
Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.
Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ When narrow current pulses drive a high Q resonant circuit the voltage across the circuit looks like
narrow pulses
half sine wave
almost sine wave
either (a) or (b)

⇒ A constant k high pass p section has a characteristic impedance of 300 Ω at f = ∞ . At f = f_c, the characteristic impedance will be
zero
∞
300 Ω
more than 300 Ω

⇒ Two coils are connected in parallel. Their fluxes are adding. If the connections of one of the coils are reversed, the total inductance of the arrangement
will decrease
may increase or decrease
will remain the same
will increase

⇒ The D'Arsonval- movement can be converted into audio frequency ac ammeter by adding a
thermocouple
transducer
chopper
rectifier

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ In a bipolar transistor
recombination in base regions of both n-p-n and p-n-p transistor is low
recombination in base regions of both n-p-n and p-n-p transistors is high
recombination in base region of n-p-n transistor is low but that in p-n-p transistor is high
recombination in base region of p-n-p transistor is low but that in n-p-n transistor is high

⇒ The resonance frequency of the circui
5.4 Kn₂
4.5 Kn₂
5 Kn₂
∞

⇒ Consider the resonant circuit as shown b
R = 10⁴ L = 5 μH C = 20 pF
1000 L = 50 μH C = 200 pF
10 K L = 50 μH C =20 pF
None of these

⇒ The standard deviation of a set of observations is the rms value of the deviation from the arithmetic mean.
TRUE
FALSE

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ A device which converts BCD to seven segment is called
encoder
decoder
multiplexer
none of these

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math