Question is ⇒ In PAL system, Options are ⇒ (A) phase of U signal is reversed on alternating lines, (B) phase of V signal is reversed on alternating lines, (C) phases of both U and V signals are reversed on alternating lines, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In PAL system, Options are ⇒ (A) phase of U signal is reversed on alternating lines, (B) phase of V signal is reversed on alternating lines, (C) phases of both U and V signals are reversed on alternating lines, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In PAL system
A.	phase of U signal is reversed on alternating lines [Wrong Answer]
B.	phase of V signal is reversed on alternating lines [Correct Answer]
C.	phases of both U and V signals are reversed on alternating lines [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For type 0 system the starting point (i.e. ω = 0) of polar plot is finite and is on positive real axis.
TRUE
FALSE

⇒ In digital computer programming, subroutines are used
to reduce program execution time at the expense of more memory
to reduce storage requirements
to increase programming ease and reduce storage requirements
because most of the functions are same

⇒ In a 5.6 ohms, ± 10% carbon composition resistor, the colour of the third strip from extreme left is
golden
silver
green
black

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ

⇒ Generally the gain of a transistor amplifier falls at high frequencies due to the
internal capacitance of device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P

⇒ When number of quantization levels are two; then the average transmission power in NRZ polar signaling is __________ that of NRZ unipolar signaling
42737
42739
42743
none of these

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒ Bit is a unit of
entropy
information
channel capacity
rate of information

⇒ Ebers Moll model is applicable to
bipolar Junction transistor
N MOS transistor
unipolar junction transistor
field effect transistor

⇒ In 8086 the instruction ADD AL, CH means
the two 8 bit values in registers AL and CH are added and result placed in register AL
the two 8 bit values in registers AL and CH are added and result placed in register CH
the two 16 bit values in registers AL and CH are added and result placed in register AL
the two 16 bit values in registers AL and CH are added and result placed in register CH

⇒ For a circular wave guide
cutoff frequency for TE₁₀ and TE₀₁ modes are same
cutoff frequency for TE₁₀ and TE₀₁ modes are different
cutoff frequency for TE₁₀ mode = twice the cutoff frequency for TE₂₀ mode
cutoff frequency for TE₁₀ mode = haf the cutoff frequency for TE₂₀ mode

⇒ Ionospheric storm causes an abnormal decrease in the critical frequency.
TRUE
FALSE

⇒ The signal m(t) = 10 cos 100 pt is sampled at the rate of F_s = 75 H_z, then determine signal after sampling.
4 cos 100 pt + 8 sin 200 pt
4 cos 100 pt + 8 sin 200 pt + cos 75 pt
4 cos 25 pt + 8 sin 50 pt + cos 75 pt
none

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ Evaluate the value of 2 [u (t - 1) - u (1 - 2t)] (u ( t + 1) + u (t)) at t = 3 sec.
0
4
∞
1

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒ Rochelle salt is a ferroelectric material.
TRUE
FALSE

⇒ During testing of an energy meter, the energy recorded by meter was 0.05 kWh and correct energy was found to be 0.09 kWh. The error and correction respectively are
-0.01 kWh and 0.01 kWh
0.01 kWh and -0.01 kWh
-0.01 kWh and ± 0.01 kWh
± 0.01 kWh and 0.01 kWh

⇒ TTL uses
multi-emitter transistors
multi-collector transistors
multi-base transistors
multi-emitter or multi-collector transistors

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ If two mutually exclusive events A and B can happen in m and n ways, then either A or B can happen in (m + n) ways.
TRUE
FALSE

⇒ The most important set of specifications of transformer oil include
dielectric strength and viscosity
dielectric strength and flash point
viscosity and flash point
flash point and viscosity

⇒ In a minimum function
the degree of numerator is higher than that of denominator
the degree of numerator is lower than that of denominator
the degree of numerator and denominator are equal
the denominator is a constant

⇒ The input and output signals for CE amplifier are always
equal
in phase
out of phase
complementary to each other

⇒ In metals, the average drift velocity of electron per unit field is called mobility.
TRUE
FALSE

⇒ A TRIAC can be turned on :
by applying a positive signal to gate
by applying a negative signal to gate
by applying either positive or negative signal to gate
none of the above

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10⁶ rad/sec. The possible combination of R, L,
2.5Ω, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 μF
5 kΩ, 0.1 mH, 0.4 μF

⇒ CCIR system B employs
625 lines
625 lines with 2 : 1 interlace
625 lines with 4 : 1 interlace
500 lines with 2 : 1 interlace

⇒ A device which converts BCD to seven segment is called
encoder
decoder
multiplexer
none of these