Question is ⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than, Options are ⇒ (A) 80 km, (B) 110 km, (C) 150 km, (D) 210 km, (E) , Leave your comments or Download question paper.

Question is ⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than, Options are ⇒ (A) 80 km, (B) 110 km, (C) 150 km, (D) 210 km, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than
A.	80 km [Correct Answer]
B.	110 km [Wrong Answer]
C.	150 km [Wrong Answer]
D.	210 km [Wrong Answer]
View Answer 35 -12 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In transmission and distribution system the permissible voltage variation is
± 1 percent
± 10 percent
± 20 percent
± 30 percent

⇒ High voltages for transmitting power is economically available from
d.c. currents
a.c. currents
carrier currents
none of the above

⇒ In transmission lines the cross-arms are made of
copper
wood
R.C.C.
steel

⇒ The ground ring transmission lines are used to
reduce the transmission losses
reduce the earth capacitance of the lowest unit
increase the earth capacitance of the lowest unit
none of the above

⇒ High voltage transmission lines use
suspension insulators
pin insulators
both (a) and (b)
none of the above

⇒ Which of the following D.C. distribution system is the simplest and lowest in first cost, ?
Radial system
Ring system
Inter-connected system
None of the above

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ Transmission line insulators are made of
glass
porcelain
iron
P.V.C.

⇒ A conductor due to sag between two supports, takes the form of
semi-circle
triangle
ellipse
catenary

⇒ In A.C.S.R. conductor the function of steel is to
provide additional mechanical strength
prevent corona
take care of surges
reduce inductance and subsequently improve power factor

⇒ Which of the following are connected by the service mains ?
Transformer and earth
Distributor and relay system
Distributor and consumer terminals
Distributor and transformer

⇒ In the cables sheaths are used to
prevent the moisture from entering the cable
provide strength to the cable
provide proper insulation
none of the above

⇒ Which of the following is the source of heat generation in the cables ?
Dielectric losses in cable insulation
IR losses in the conductor
Losses in the metallic sheathings and armourings
All of the above

⇒ For transmission of power over a distance of 200 km, the transmission voltage should be
132 kV
66 kV
33 kV
11 kV

⇒ The top most conductor in a high transmission line is
earth conductor
R-phase conductor
Y-phase conductor
B-phase conductor

⇒ Which of the following are the constants of the transmission lines ?
Resistance
Inductance
Capacitance
All of the above

⇒ Which of the following can be used for bus-bars ?
Tubes
Rods
Bars
Any of the above

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ Due to which of the following reasons aluminium is being favoured as busbar material ?
Low density
Low cost
Ease of fabrication
None of the above

⇒ The effective resistance of a conductor will be the same as 'ohmic resistance' when
power factor is unity
current is uniformly distributed in the conductor cross-section
voltage is low
current is in true sine wave form

⇒ If the height of transmission tower is increased
the line capacitance will decrease but line inductance will remain unchanged
the line capacitance and inductance will not change
the line capacitance will increase but line inductance will decrease
the line capacitance will decrease and line inductance will increase

⇒ Galvanised steel wire is generally used as
stay wire
earth wire
structural components
all of the above

⇒ Electro-mechanical voltage regulators are generally used in
reactors
generators
transformers
all of the above

⇒ By which of the following methods voltage of transmission can be regulated ?
Use of series capacitors to neutralise the effect of series reactance
Switching in shunt capacitors at the receiving end during heavy loads
Use of tap changing transformers
Any of the above methods

⇒ In a D.C. 3-wire distribution system, balancer fields are cross-connected in order to
boost the generated voltage
balance loads on both sides of the neutral
make both machines run as unloaded motors
equalize voltages on the positive and negative outers

⇒ Which of the following materials is not used for transmission and distribution of electrical power ?
Copper
Aluminium
Steel
Tungsten

⇒ As compared to a 2-wire D.C. distributor, a 3-wire distributor with same maximum voltage to earth uses only
31.25 percent of copper
33.3 percent of copper
66.7 percent of copper
125 percent of copper

⇒ Transmission voltage of 11 kV is normally used for distances upto
20-25 km
40-50 km
60-70 km
80-100 km

⇒ In which of the following cases shunt capacitance is negligible ?
Short transmission lines
Medium transmission lines
Long transmission lines
All transmission lines

⇒ Owing to skin effect
current flows through the half cross-section of the conductor
portion of the conductor near the surface carries more current and core of the conductor carries less current
portion of the conductor near the surface carries less current and core of the conductor carries more current
any of the above