Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In order to achieve good stabilization in potential divider method current I_{1} through R_{1} and R_{2} should be |

A. | I_{1} > 20 I_{B} [Wrong Answer] |

B. | I_{1} > 15 I_{B} [Wrong Answer] |

C. | I_{1} < 5 I_{B} [Wrong Answer] |

D. | I_{1} > 10 I_{B} [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In

*n*type semiconductor, the free electron concentration

is nearly equal to density of donor atoms

is much greater than density of donor atoms

is much less than density of donor atoms

may be equal to or more or less than density of donor atoms

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100,

*g*= 0.3861 A/V,

_{m}*r*

_{0}= ∞

*r*= 259 Ω, R

_{p}_{s}= 1 kΩ, R

_{B}= 93 kΩ, R

_{C}= 250 Ω, R

_{L}= 1 kW, C

_{1}= ∞ and C

_{2}= 4.

33.9 Hz

27.1 Hz

13.6 Hz

16.9 Hz

⇒ The number of cells in a 4 variable K map is

16

8

4

32

⇒ Each kilometer of travel in electromagnetic radiation means a time delay of

330 μs

33 μs

3.3 μs

0.33 μs

⇒ Consider the following program in B

2.827

28.27

282.7

2827

⇒ Measurement of hall coefficient enables the determination of

mobility of charge carriers

type of conductivity and concentration of charge carriers

temperature coefficient and concentration of charge carriers

fermi level and forbidden energy gap

⇒ Choose correct option for a stable system :

- Roots of the characteristic equation of the system are real and negative
- Area within the impulse response is finite

I is true, II is true

I is true, II is false

I is false, II is true

I is false, II is false

⇒

**Assertion (A):** L[*e*^{-at}*f*(*t*)] = F(*s* + *a*)

**Reason (R):** In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is true, R is false

A is false, R is true

⇒ Sparking affects amplitude modulation.

TRUE

FALSE

⇒ When a plane wave is incident normally from dielectric '1' (μ

_{0}, ε

_{1}) onto dielectric '2' (μ

_{0}, ε

_{2}) the electric field of the transmitted wave is 2 times the electric field of the reflected wave. The ratio ε

_{2}/ε

_{1}is

0.5

1

2

4

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of

1

-1

0

3

⇒ In CCD

a small charge is deposited for logical 1

a small charge is deposited for both logical 1 and 0

a small charge is deposited for logical 0 and large charge for logical 1

none of the above

⇒ The stack pointer holds the address of the desired memory location.

TRUE

FALSE

⇒ The number of flip flops needed for a Mod 7 counter are

7

5

3

1

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?

Power can be measured by this method only for star connected loads

When two wattmeters have equal readings power factor is 0.5.

When power factor is 1, one of the wattmeters readings is zero

When the two wattmeter read equal and opposite, p.f. is zero.

⇒ A sample of N type semiconductor has electron density of 6.25 x 10

^{8}/cm

^{2}at 300 K. If the intrinsic concentration of carriers in this sample is 2.5 x 10

^{13}/cm

^{3}at this temperature, the hole density works out to be

10

^{6}/cm

^{3}

10

^{8}/cm

^{3}

10

^{10}/cm

^{3}

10

^{l2}/cm

^{3}

⇒ Which of the following statements is/are true for a good conductor of electricity?

- Its conductivity decreases with increasing temperature.
- Number of free electrons is around 10
^{28}m^{-3}. - Its conductivity decreases with addition of impurities.
- It is a good conductor of heat also.

1, 2, 3 and 4

1 only

2 and 3 only

3 and 4 only

⇒ In dielectric heating, the thyristor circuits consist of

rectifier-chopper combination

controlled rectifier

ac regulator

rectifier-inverter combination

⇒ In a shield helix

the spacing between adjacent turns is very large

the spacing between adjacent turns approaches zero

the spacing between adjacent turns approaches zero and wire thickness approaches zero

the spacing between adjacent turns is very large wire thickness approaches zero

⇒ Which of the following is invariably found in SSB?

Tuned modulator

Class B, RF amplifier

Class C, audio amplifier

All of the above

⇒

Match the following:

List I (Diode Rectifier) | List II (Efficiency is R_{f}/R_{L} = 0.25) | ||
---|---|---|---|

A. | Half wave | 1. | 0.54 |

B. | Bridge Rectifier | 2. | 0.65 |

C. | Full wave using tapped centre transformer | 3. | 0.325 |

A-1, B-2, C-3

A-2, B-1, C-3

A-3, B-2, C-1

A-3, B-1, C-2

⇒ For the given figure C(

*s*)/R(

*s<*

K

0.5 K

2 K

0.25 K

K

0.5 K

2 K

0.25 K

⇒ A lag compensator is essentially a

low pass filter

high pass filter

band pass filter

either (a) or (b)

⇒ The hexadecimal number 5 F is equal to binary number

1010011

1011001

1010101

1011111

⇒ In the given figure, the input frequency is such that R = X

⇒ For a BJT if β = 50, I

1 mA

1.2 mA

1.3 mA

1.4 mA

⇒ The scale of hot wire ammeter is

linear

non-linear

cramped

absolute linear

⇒ A two terminal black box contains one of the elements R, L, C. The black box is connected to 220 V as supply. The current is I, when a capacitance of 0.1 F is connected in series between the source and box, the current is 2I. The elements is

resistance

inductance

capacitance of 0.5 F

not identifiable form the given data

⇒ A square corner reflector is used in which of the following?

TV broadcast

Point-to-point communication

Radio astronomy

All of the above

⇒ In a series resonant circuit, the resonant frequency is

geometric mean of half power frequencies

arithmetic mean of half power frequencies

difference of half power frequencies

none of the above

⇒ A lag compensator is essentially a

low pass filter

high pass filter

band pass filter

either (a) or (b)

⇒ The hexadecimal number 5 F is equal to binary number

1010011

1011001

1010101

1011111

⇒ In the given figure, the input frequency is such that R = X

_{C}.*v*_{0}lags*v*_{i}by 45°*v*_{0}lags*v*_{i}by 90°*v*_{0}leads*v*_{i}by 45°*v*_{0}leads*v*_{i}by 90°⇒ For a BJT if β = 50, I

_{CEO}= 3 μA and I_{C}= 1.2 mA then I_{E}1 mA

1.2 mA

1.3 mA

1.4 mA

⇒ The scale of hot wire ammeter is

linear

non-linear

cramped

absolute linear

⇒ A two terminal black box contains one of the elements R, L, C. The black box is connected to 220 V as supply. The current is I, when a capacitance of 0.1 F is connected in series between the source and box, the current is 2I. The elements is

resistance

inductance

capacitance of 0.5 F

not identifiable form the given data

⇒ A square corner reflector is used in which of the following?

TV broadcast

Point-to-point communication

Radio astronomy

All of the above

⇒ In a series resonant circuit, the resonant frequency is

geometric mean of half power frequencies

arithmetic mean of half power frequencies

difference of half power frequencies

none of the above