Question is ⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is, Options are ⇒ (A) ASCII, (B) Excess 3 CODE, (C) Gray CODE, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is, Options are ⇒ (A) ASCII, (B) Excess 3 CODE, (C) Gray CODE, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
A.	ASCII [Wrong Answer]
B.	Excess 3 CODE [Wrong Answer]
C.	Gray CODE [Correct Answer]
D.	none of these [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The method of triggering SCS is
application of positive pulse at cathode gate or negative pulse at anode gate
application of pulse at anode gate
application of pulse at cathode gate
application of low voltage at anode

⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V₀/V_i should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ A system has high gain and phase margin. The system is
very stable
sluggish
very stable and sluggish
oscillatory

⇒

Assertion (A): Impulse function is an important function in network analysis.

Reason (R): Convolution integral enables us to find the response of a network to an arbitary input in terms of the impulse response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ A capacitor input filter relies on
average detection
peak detection
both (a) and (b)
neither (a) nor (b)

⇒ In 8086 the instruction ADD AL, CH means
the two 8 bit values in registers AL and CH are added and result placed in register AL
the two 8 bit values in registers AL and CH are added and result placed in register CH
the two 16 bit values in registers AL and CH are added and result placed in register AL
the two 16 bit values in registers AL and CH are added and result placed in register CH

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is
100 MHz
50 MHz
12.5 MHz
6.25 MHz

⇒ Registers and counters are similar in the sense that they both
count pulses
store binary information
are made from an array of flip-flops and gates integrated on a single chip
are shift registers

⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?
0.375 V
15 V
4.5 V
10 V

⇒ In a R-L-C circuit at resonance is
maximum in series resonance and minimum in parallel resonance.
maximum in parallel resonance and minimum in series resonance
minimum in both series and parallel resonances
maximum in both series and parallel resonances.

⇒ RC oscillator can be used upto
1 kHz
10 kHz
50 kHz
100 kHz

⇒ F.T. of continuous non-periodic signal is
aperiodic
periodic
a and b
none

⇒ FM has poor efficiency than
AM
AM-SC
PAM
PCM

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ A video transmission system transmits 625 picture frames per second. Each frame consist of a 400 x 400 pixel grid with 64 intensity levels per pixel. The data rate of the system is
16 Mbps
100 Mbps
600 Mbps
6.4 Gbps

⇒ A microprocessor uses 3 MHz oscillator. The duration of one T state is
1 μs
0.666 μs
0.333 μs
3 μs

⇒ Which of the following is not a general purpose peripheral?
I/O port
Programmable interrupt controller
Programmable CRT controller
Programmable interval timer

⇒ The circuit in the figure is has two CMOS-NOR gates. This circuit functions
flip-flop
schmitt trigger
monostable multivibrator
astable multivibrator

⇒ The effective height of a vertical radiator can be increased by
loading with lumped inductance
supporting on an insulator
capacitive loading
giving input more power

⇒ Out of multiplexer and demultiplexer, which can be used as a logic function generator?
Multiplexer only
Demultiplexer only
Both
None

⇒ To realize following function 'f'3
6
4
10

⇒ In a digital circuit, a clock is a
crystal type
multivibrator
flip-flop
free running multivibrator

⇒
Match the following:
List I List II
A. True type 1. Type of calculator in window
B. FIND 2. Window command
C. WORD PAD 3. Name of a Font
D. STANDARD 4. Has many features of a simple word processor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-3, B-2, C-4, D-1

	List I		List II
A.	True type	1.	Type of calculator in window
B.	FIND	2.	Window command
C.	WORD PAD	3.	Name of a Font
D.	STANDARD	4.	Has many features of a simple word processor

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math