Question is ⇒ In most of instruments, the controlling torque is provided by, Options are ⇒ (A) fluid fraction, (B) spring, (C) eddy current, (D) either (a) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ In most of instruments, the controlling torque is provided by, Options are ⇒ (A) fluid fraction, (B) spring, (C) eddy current, (D) either (a) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In most of instruments, the controlling torque is provided by
A.	fluid fraction [Wrong Answer]
B.	spring [Wrong Answer]
C.	eddy current [Correct Answer]
D.	either (a) or (c) [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : LiFE CHAnGer Said on 2020-06-08 02:27:16 controlling torque tho spring hona chahiye !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A backward wave oscillator has an internal positive feedback.

Reason (R): A positive feedback is necessary for sustained oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The reading of the voltmeter V in figure should be __________ v
60
10
66
0

⇒ Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
IF stage
RF stage
power amplification stage
none of the above

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ A bipolar differential amplifier uses a transistor having β₀ = 200, I_CQ = 100 mA, |A_dm| = 500 and CMRR = 80 dB. The value of R_c and R_E will be respectively __________ .
1.25 kΩ, 1.25 MΩ
125 kΩ, 1.25 MΩ
1.25 MΩ, 1.25 kΩ
3.25 kΩ, 3.25 MΩ

⇒ Two transistors have same value of a but different gain (G) bandwidth (B) product. The transistors have similar geometry. However one of them is germanium and the other is silicon. The transistor with lower GB product
is germanium
is silicon
may be either of two
cannot be identified on the basis of above data

⇒ A string of series connected thyristors needs equalising circuit to
ensure proper firing
ensure proper current division
ensure proper voltage division
none of the above

⇒ The circuit given bel
Circuit is band stop with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is band pass with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is oscillator, oscillation at two frequencies 39.7875 Hz to 1592 Hz depending on R₃, R₄, R₅ and R₆
None of these

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE

⇒ The output y(t) of a continuous-time system S for the input x(t) is given
S is linear and time-invariant
S is linear and time-varying
S is non-linear and time-invariant
S is non-linear and time-varying

⇒ In DTL the junction transistor serves as
inverter
buffer amplifier
both (a) and (b)
none of the above

⇒ In a rectifier circuit the filter capacitance is increased. Then the ripple will
increase
decrease
remain the same
either (a) or (b)

⇒ Consider the following statements about constants in 8085

The assembler treats 64 H as hexadecimal constant.
The assembler treats 154 as binary constant.
The assembler treats 540 as octal constant.
The assembler treats 138 as decimal constant.

Which of the above are correct?
1, 2 and 3 only
1, 3 and 4 only
1 and 3 only
2 and 4 only

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ Gain margin and phase margin can be determined from Bode plots as well as Nyquist plot.
TRUE
FALSE

⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top

⇒ Soft iron is suitable for making temporary magnets.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Servomotor	1.	Error detector
B.	Amplidyne	2.	Transducer
C.	Potentiometer	3.	Actuator
D.	Flapper valve	4.	Power amplifier

A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE

⇒ Personal computer cannot be used for which one of the following?
Game playing
Weather forecasting
Office Automation
Home computing

⇒ Which antenna is a wideband antenna?
Hertz antenna
Marconi antenna
Folded dipole
None of the above

⇒ It is very likely in __________ gate family that when one gate is driving number of gates in __________ , a gate having least voltage for saturation may consume large __________ leaving other gates inoperative and this phenomenon is called __________ .
DTL, parallel, current, current - sinking
DCTL, parallel, current, current-lagging
ECL, series, voltage, voltage-deterioration
DCTL, series, current, current-lagging

⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE

⇒ In 8085 microprocessor, which of the following interrupts has the lowest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above

⇒ In an R-L-C series circuit, R = 2/L/C . If R is doubled
the response will become underdamped
the response will become overdamped
the response will be critically damped
the response may be under damped or overdamped

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

controlling torque tho spring hona chahiye