Question is ⇒ In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about, Options are ⇒ (A) 0.1, (B) 1.25, (C) 5, (D) 10, (E) , Leave your comments or Download question paper.

Question is ⇒ In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about, Options are ⇒ (A) 0.1, (B) 1.25, (C) 5, (D) 10, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about
A.	0.1 [Wrong Answer]
B.	1.25 [Correct Answer]
C.	5 [Wrong Answer]
D.	10 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ MS Excel is an application software for financial planning.
TRUE
FALSE

⇒ Find equivalent resistance. Each resistance is l &Om
5/12 Ω
5/6 Ω
6/5 Ω
6/10 Ω

⇒ The total insulation resistance consists of insulation volume resistance and surface leakage resistance.
TRUE
FALSE

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒ Find resistance R_B to bring transistor to threshold of saturation V_CB = 0, V_BE = 0.7 V, a =
1.5 kΩ
15 kΩ
10 kΩ
1 kΩ

⇒ An homogeneous dielectric material is subjected to an electric field E. If a small cavity is made inside the material, the electric field intensity inside and outside the cavity are different.
TRUE
FALSE

⇒ In a CE amplifier the collector resistance is short circuited. The ac output voltage will
increases
remains the same
increases or decreases
decreases

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ In a digital system, the maximum clock frequency that can be used with Master/Slave Clocked flip-flops having total propagation delay of 200 μsec is
20 MHz
50 MHz
100 MHz
200 MHz

⇒ The main disadvantage of the two-hole directional coupler is
poor directivity
narrow bandwidth
high standing wave ratio
low directional coupling

⇒ PIL tube means
Picture in Line Tube
Precision in Line Tube
Pairing in Line Tube
Pattern in Line Tube

⇒ The F.T. of a conjugate symmetric function is always
imaginary
real
conjugate Unsymmetric
conjugate symmetric

⇒ In a minimum phase system
all poles lie in the left half plane
all zeros lie in the left half plane
all poles lie in the right half plane
all except one pole or zero lie in the left half plane

⇒ The number of bits in a nibble is
8
4
2
16

⇒ In transistor radio receivers the number of IF amplifier stages are
1
2
4
6

⇒ The angle subtended by earth at geostationary communication satellite is
17.34°
51.4°
120°
60°

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ When a P-N junction is unbiased, the junction current at equilibrium is
zero as no charges cross the junction
zero as equal number of carriers cross the barrier
mainly due to diffusion of majority carriers
mainly due to diffusion of minority carriers

⇒ In a reverse biased p-n junction, the reverse bias is 4V. The junction capacitance is about
0.1 F
4 μF
10 nF
20 pF

⇒ In TE₁₀mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)

⇒ For a series R-L-C circuit tuned at resonant frequency which of the following statements is correct?
The voltage across inductance is greater than applied voltage
The voltage across capacitance is greater than applied voltage
The voltage across both inductance and capacitance is greater than applied voltage
The voltage across both inductance and capacitance is less than applied voltage

⇒ Which of the following does not use the principle of change in inductance?
LVDT
Inductance displacement transducer
Strain gauge
Reluctance pick up

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has I_CBO = 400 nA at 25°C, then its leakage current at 80°C
10 μA
18 μA
20 μA
15 μA

⇒ In the given figure the reflected voltage wave after first reflectio
18 V
-18 V
30 V
-30 V

⇒ A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is
300 mW
330 mW
350 mW
380 mW

⇒ In 8085 the term 'absolute addressing' means
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ The material which has zero temperature coefficient of resistance is
manganin
porcelain
carbon
aluminium

⇒ A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) wh
-6
zero
2
-4